[PATCH] ARM: dts: at91: enable watchdog for SAMA5D3 Xplained
Nicolas Ferre
nicolas.ferre at microchip.com
Mon Dec 13 07:48:20 PST 2021
On 09/12/2021 at 16:45, Michael Opdenacker wrote:
> Like on the SAMA5D2 and SAMA5D4 Xplained boards,
> enable the watchdog device on the SAMA5D3 Xplained board.
>
> As explained on drivers/watchdog/at91sam9_wdt.c,
> for the watchdog driver to work in Linux, you need to make sure
> that the bootstrap / bootloader doesn't disable the watchdog,
> as the Watchdog Timer Mode Register can be only written to once.
>
> Signed-off-by: Michael Opdenacker <michael.opdenacker at bootlin.com>
Hi Michael,
Thanks for your patch.
Even if I understand the need for alignment with other sama5 SoCs, I'm
not planning to take this patch to enable the watchdog by default.
As you highlight, this older watchdog, compared to the ones on sama5d4
or sama5d2, cannot be re-enabled.
On our usual prebuilt demos and configurations, that don't have watchdog
support by default, enabling it triggers the following errors:
at91_wdt fffffe40.watchdog: watchdog is disabled
at91_wdt: probe of fffffe40.watchdog failed with error -22
I prefer to let the user enable the watchdog explicitly, on the whole
chain of components for its use-case and make sure to "pet" it correctly.
Best regards,
Nicolas
> ---
> arch/arm/boot/dts/at91-sama5d3_xplained.dts | 4 ++++
> 1 file changed, 4 insertions(+)
>
> diff --git a/arch/arm/boot/dts/at91-sama5d3_xplained.dts b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> index d72c042f2850..440eccc9eb38 100644
> --- a/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> +++ b/arch/arm/boot/dts/at91-sama5d3_xplained.dts
> @@ -79,6 +79,10 @@ timer1: timer at 1 {
> };
> };
>
> + watchdog: watchdog at fffffe40 {
> + status = "okay";
> + };
> +
> i2c0: i2c at f0014000 {
> pinctrl-0 = <&pinctrl_i2c0_pu>;
> status = "okay";
> --
> 2.25.1
>
--
Nicolas Ferre
More information about the linux-arm-kernel
mailing list