[RFC PATCH v4 0/4] Add Naneng combo PHY support for RK3568

[Nicolas Frattaroli]

On Mittwoch, 8. Dezember 2021 19:54:45 CET Johan Jonker wrote:
> This phy can be used as pcie-phy, usb3-phy, sata-phy or sgmii-phy.
> 
> =============================================
> 
> Changed V4 by Johan Jonker:
>   TEST COMPILED ONLY!
>   Driver not verified with hardware!
>   Produced in the hope that we can get some review progress
>   with this serie for the documents and driver.
>   Use at your own risk!
> 
>   restyle
>   add devm_reset_control_array_get()
>   remove clk structure
>   change refclk DT parse
>   change dev_err message
>   add dot to phrase
>   add ext_refclk variable
>   add enable_ssc variable
>   rename rockchip_combphy_param_write
>   remove param_read
>   replace rockchip-naneng-combphy driver name
> 
>   rename node name
>   remove reset-names
>   move #phy-cells
>   add rockchip,rk3568-pipe-grf
>   add rockchip,rk3568-pipe-phy-grf
> 
> =============================================
> 

Tested-by: Nicolas Frattaroli <frattaroli.nicolas at gmail.com>

Applied this on top of 5.16-rc4, added the necessary device tree
changes to rk356x.dtsi and rk3566-quartz64-a.dts and ran it on
my Quartz64. I tested PCIe2x1 on the one combphy and SATA on the
other, simultaneously. Devices were detected correctly (with some
hiccups on SATA due to a Quartz64 Model A design issue, but it
was detected eventually) and some transfers were done to ensure
it's stable. It is stable.

Regards,
Nicolas Frattaroli