[PATCH] arm64: dts: ti: iot2050: Disable mcasp nodes at dtsi level

[Jan Kiszka]

On 17.11.21 06:38, Jayesh Choudhary wrote:
> Disable mcasp nodes 0-2 because several required properties
> are not present in the dtsi file as they are board specific.
> These nodes can be enabled via an overlay whenever required.
> 
> Signed-off-by: Jayesh Choudhary <j-choudhary at ti.com>
> ---
>  arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi b/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
> index 65da226847f4..c9407ed67866 100644
> --- a/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
> @@ -731,3 +731,15 @@
>  &icssg2_mdio {
>  	status = "disabled";
>  };
> +
> +&mcasp0 {
> +	status = "disabled";
> +};
> +
> +&mcasp1 {
> +	status = "disabled";
> +};
> +
> +&mcasp2 {
> +	status = "disabled";
> +};
> 

Acked-by: Jan Kiszka <jan.kiszka at siemens.com>

Sorry for the delay.

Jan

-- 
Siemens AG, T RDA IOT
Corporate Competence Center Embedded Linux