[PATCH v2 05/14] dt-bindings: gpio: Convert Broadcom STB GPIO to YAML

[Florian Fainelli]

On 12/7/21 6:58 AM, Rob Herring wrote:
> On Mon, 06 Dec 2021 10:26:07 -0800, Florian Fainelli wrote:
>> Convert the Broadcom STB GPIO Device Tree binding to YAML to help with
>> validation.
>>
>> Signed-off-by: Florian Fainelli <f.fainelli at gmail.com>
>> ---
>>  .../bindings/gpio/brcm,brcmstb-gpio.txt       |  83 --------------
>>  .../bindings/gpio/brcm,brcmstb-gpio.yaml      | 105 ++++++++++++++++++
>>  MAINTAINERS                                   |   2 +-
>>  3 files changed, 106 insertions(+), 84 deletions(-)
>>  delete mode 100644 Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.txt
>>  create mode 100644 Documentation/devicetree/bindings/gpio/brcm,brcmstb-gpio.yaml
>>
> 
> Running 'make dtbs_check' with the schema in this patch gives the
> following warnings. Consider if they are expected or the schema is
> incorrect. These may not be new warnings.
> 
> Note that it is not yet a requirement to have 0 warnings for dtbs_check.
> This will change in the future.
> 
> Full log is available here: https://patchwork.ozlabs.org/patch/1564132
> 
> 
> gpio at 4172c0: interrupts-extended: [[6, 6], [7, 5]] is too long
> 	arch/arm/boot/dts/bcm7445-bcm97445svmb.dt.yaml

The property is correct AFAICT, we have:

                        interrupts-extended = <&irq0_aon_intc 0x6>,
                                              <&aon_pm_l2_intc 0x5>;

with both interrupt controllers having #interrupt-cells = <1>. I tried
documenting the interrupts-extended for brcm,brcmstb-gpio.yaml to have
maxItems: 2 but that does not eliminate the warning. Do you have any
suggestions?
-- 
Florian