[PATCH 1/2] arm64: dts: ls1088a: Add reboot nodes

[Li Yang]

ls1088a has a separate reset register block.  Define it in dts and use
it for reboot.

Signed-off-by: Ashish Kumar <Ashish.Kumar at nxp.com>
Signed-off-by: Li Yang <leoyang.li at nxp.com>
---
 arch/arm64/boot/dts/freescale/fsl-ls1088a.dtsi | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1088a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1088a.dtsi
index f891ef6a3754..1eda080b497c 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1088a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1088a.dtsi
@@ -206,6 +206,13 @@ sysclk: sysclk {
 		clock-output-names = "sysclk";
 	};
 
+	reboot {
+		compatible = "syscon-reboot";
+		regmap = <&reset>;
+		offset = <0x0>;
+		mask = <0x02>;
+	};
+
 	soc {
 		compatible = "simple-bus";
 		#address-cells = <2>;
@@ -226,6 +233,11 @@ dcfg: dcfg at 1e00000 {
 			little-endian;
 		};
 
+		reset: syscon at 1e60000 {
+			compatible = "fsl,ls1088a-reset", "syscon";
+			reg = <0x0 0x1e60000 0x0 0x10000>;
+		};
+
 		isc: syscon at 1f70000 {
 			compatible = "fsl,ls1088a-isc", "syscon";
 			reg = <0x0 0x1f70000 0x0 0x10000>;
-- 
2.25.1