[PATCH v7 3/8] dt-bindings: imx6q-pcie: Add PHY phandles and name properties

[Richard Zhu]

i.MX8MM PCIe has the PHY. Add a PHY phandle and name properties
in the binding document.

Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
Tested-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
Reviewed-by: Tim Harvey <tharvey at gateworks.com>
Tested-by: Tim Harvey <tharvey at gateworks.com>
Reviewed-by: Rob Herring <robh at kernel.org>
---
 Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
index acea1cd444fd..643a6333b07b 100644
--- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
+++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
@@ -127,6 +127,12 @@ properties:
     enum: [1, 2, 3, 4]
     default: 1
 
+  phys:
+    maxItems: 1
+
+  phy-names:
+    const: pcie-phy
+
   reset-gpio:
     description: Should specify the GPIO for controlling the PCI bus device
       reset signal. It's not polarity aware and defaults to active-low reset
-- 
2.25.1