[PATCH v3 2/2] dt-bindings: bus: imx-weim: add words about continuous bclk

[Ivan Bornyakov]

Document continuous Burst Clock option. With this option Burst Clock, if
enabled, will output continuous clock, otherwise Burst Clock will output
clock only when necessary.

Signed-off-by: Ivan Bornyakov <i.bornyakov at metrotek.ru>
---
 Documentation/devicetree/bindings/bus/imx-weim.txt | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/bus/imx-weim.txt b/Documentation/devicetree/bindings/bus/imx-weim.txt
index 1b1d1c5c21ea..e7f502070d77 100644
--- a/Documentation/devicetree/bindings/bus/imx-weim.txt
+++ b/Documentation/devicetree/bindings/bus/imx-weim.txt
@@ -48,6 +48,11 @@ Optional properties:
 			devices, the presence of this property indicates that
 			the weim bus should operate in Burst Clock Mode.
 
+ - fsl,continuous-burst-clk	Make Burst Clock to output continuous clock.
+			Without this option Burst Clock will output clock
+			only when necessary. This takes effect only if
+			"fsl,burst-clk-enable" is set.
+
 Timing property for child nodes. It is mandatory, not optional.
 
  - fsl,weim-cs-timing:	The timing array, contains timing values for the
-- 
2.32.0