[PATCH v1 2/7] ARM: imx_v6_v7_defconfig: enable fb

[Stefan Wahren]

Hi,

Am 26.08.21 um 21:03 schrieb Fabio Estevam:
> Hi Marcel,
>
> On Thu, Aug 19, 2021 at 11:04 AM Marcel Ziswiler <marcel at ziswiler.com> wrote:
>> From: Marcel Ziswiler <marcel.ziswiler at toradex.com>
>>
>> Enable CONFIG_FB which is nowadays required for CONFIG_DRM_PANEL_LVDS,
>> CONFIG_DRM_PANEL_SIMPLE, CONFIG_DRM_PANEL_SEIKO_43WVF1G,
>> CONFIG_FB_MODE_HELPERS, CONFIG_BACKLIGHT_PWM, CONFIG_BACKLIGHT_GPIO,
>> CONFIG_FRAMEBUFFER_CONSOLE, CONFIG_LOGO, CONFIG_FONTS, CONFIG_FONT_8x8
>> and CONFIG_FONT_8x16.
>>
>> Signed-off-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
> Yes, I noticed that I had no LCD output on an imx6ull-evk board and
> after selecting CONFIG_FB it works again.

this was caused by:

f611b1e7624c ("drm: Avoid circular dependencies for CONFIG_FB")

Best regards

>
> For the entire series:
>
> Reviewed-by: Fabio Estevam <festevam at gmail.com>
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel