[PATCH v3 0/4] mmc: pwrseq: sd8787: add support wilc1000 devices

[Ulf Hansson]

On Fri, 20 Aug 2021 at 11:30, Claudiu Beznea
<claudiu.beznea at microchip.com> wrote:
>
> Hi,
>
> This series adds support for WILC1000 devices on pwrseq-sd8787 driver.
> WILC1000 devices needs a minimum delay of 5ms b/w reset and power lines.
> Adapt the sd8787 driver for this by adding a new compatible for WILC1000
> devices and specify the delay on .data field of struct of_device_id.
>
> Thank you,
> Claudiu Beznea
>
> Changes in v3:
> - fixed dt binding compilation
>
> Changes in v2:
> - changed cover letter title (it was: mmc: pwrseq: sd8787: add support
>   for selectable)
> - use new compatible in pwrseq-sd8787 driver instead of adding a new
>   binding for specifying the delay; with this, the patch 1/1 from v1 is
>   not necessary
> - adapt patch 3/3 from this version with the new compatible
>
>
> Claudiu Beznea (3):
>   dt-bindings: pwrseq-sd8787: add binding for wilc1000
>   mmc: pwrseq: sd8787: add support for wilc1000
>   mmc: pwrseq: add wilc1000_sdio dependency for pwrseq_sd8787
>
> Eugen Hristev (1):
>   ARM: dts: at91: sama5d27_wlsom1: add wifi device
>
>  .../bindings/mmc/mmc-pwrseq-sd8787.yaml       |  4 +-
>  arch/arm/boot/dts/at91-sama5d27_wlsom1.dtsi   | 71 +++++++++++++++++++
>  drivers/mmc/core/Kconfig                      |  2 +-
>  drivers/mmc/core/pwrseq_sd8787.c              | 11 ++-
>  4 files changed, 84 insertions(+), 4 deletions(-)
>

Applied patch1 -> patch3, thanks! I leave patch 4 for soc maintainers.

Kind regards
Uffe