[PATCH v4 05/12] firmware: arm_scmi: Use new trace event scmi_xfer_response_wait

[Cristian Marussi]

Use new trace event to mark start of waiting for response section.

Signed-off-by: Cristian Marussi <cristian.marussi at arm.com>
---
 drivers/firmware/arm_scmi/driver.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c
index 2ca1602afd80..1320a00a6339 100644
--- a/drivers/firmware/arm_scmi/driver.c
+++ b/drivers/firmware/arm_scmi/driver.c
@@ -786,6 +786,11 @@ static int scmi_wait_for_message_response(struct scmi_chan_info *cinfo,
 	struct device *dev = info->dev;
 	int ret = 0, timeout_ms = info->desc->max_rx_timeout_ms;
 
+	trace_scmi_xfer_response_wait(xfer->transfer_id, xfer->hdr.id,
+				      xfer->hdr.protocol_id, xfer->hdr.seq,
+				      xfer->hdr.poll_completion,
+				      info->desc->atomic_capable);
+
 	if (!xfer->hdr.poll_completion) {
 		if (!info->desc->atomic_capable) {
 			if (!wait_for_completion_timeout(&xfer->done,
-- 
2.17.1