[PATCH v2 1/4] ASoC: rockchip: add support for i2s-tdm controller
Philipp Zabel
p.zabel at pengutronix.de
Mon Aug 23 05:03:25 PDT 2021
Hi Nicolas,
On Fri, 2021-08-20 at 20:27 +0200, Nicolas Frattaroli wrote:
[...]
> diff --git a/sound/soc/rockchip/rockchip_i2s_tdm.c b/sound/soc/rockchip/rockchip_i2s_tdm.c
> new file mode 100644
> index 000000000000..c02b66f3c913
> --- /dev/null
> +++ b/sound/soc/rockchip/rockchip_i2s_tdm.c
> @@ -0,0 +1,1737 @@
[...]
> +static void rockchip_snd_xfer_reset_assert(struct rk_i2s_tdm_dev *i2s_tdm,
> + int tx_bank, int tx_offset,
> + int rx_bank, int rx_offset)
> +{
> + void __iomem *cru_reset;
> + unsigned long flags;
> +
> + cru_reset = i2s_tdm->cru_base + i2s_tdm->soc_data->softrst_offset;
> +
> + if (tx_bank == rx_bank) {
> + writel(BIT(tx_offset) | BIT(rx_offset) |
> + (BIT(tx_offset) << 16) | (BIT(rx_offset) << 16),
> + cru_reset + (tx_bank * 4));
> + } else {
> + local_irq_save(flags);
> + writel(BIT(tx_offset) | (BIT(tx_offset) << 16),
> + cru_reset + (tx_bank * 4));
> + writel(BIT(rx_offset) | (BIT(rx_offset) << 16),
> + cru_reset + (rx_bank * 4));
> + local_irq_restore(flags);
> + }
> +}
> +
> +static void rockchip_snd_xfer_reset_deassert(struct rk_i2s_tdm_dev *i2s_tdm,
> + int tx_bank, int tx_offset,
> + int rx_bank, int rx_offset)
> +{
> + void __iomem *cru_reset;
> + unsigned long flags;
> +
> + cru_reset = i2s_tdm->cru_base + i2s_tdm->soc_data->softrst_offset;
> +
> + if (tx_bank == rx_bank) {
> + writel((BIT(tx_offset) << 16) | (BIT(rx_offset) << 16),
> + cru_reset + (tx_bank * 4));
> + } else {
> + local_irq_save(flags);
> + writel((BIT(tx_offset) << 16),
> + cru_reset + (tx_bank * 4));
> + writel((BIT(rx_offset) << 16),
> + cru_reset + (rx_bank * 4));
> + local_irq_restore(flags);
> + }
> +}
> +
> +/*
> + * Makes sure that both tx and rx are reset at the same time to sync lrck
> + * when clk_trcm > 0.
> + */
> +static void rockchip_snd_xfer_sync_reset(struct rk_i2s_tdm_dev *i2s_tdm)
> +{
> + int tx_id, rx_id;
> + int tx_bank, rx_bank, tx_offset, rx_offset;
> +
> + if (!i2s_tdm->cru_base || !i2s_tdm->soc_data)
> + return;
> +
> + tx_id = i2s_tdm->tx_reset_id;
> + rx_id = i2s_tdm->rx_reset_id;
> + if (tx_id < 0 || rx_id < 0)
> + return;
> +
> + tx_bank = tx_id / 16;
> + tx_offset = tx_id % 16;
> + rx_bank = rx_id / 16;
> + rx_offset = rx_id % 16;
> + dev_dbg(i2s_tdm->dev,
> + "tx_bank: %d, rx_bank: %d, tx_offset: %d, rx_offset: %d\n",
> + tx_bank, rx_bank, tx_offset, rx_offset);
> +
> + rockchip_snd_xfer_reset_assert(i2s_tdm, tx_bank, tx_offset,
> + rx_bank, rx_offset);
> +
> + udelay(150);
> +
> + rockchip_snd_xfer_reset_deassert(i2s_tdm, tx_bank, tx_offset,
> + rx_bank, rx_offset);
> +}
I'm not too fond of reimplementing half a reset controller in here.
The reset framework does not support synchronized (de)assertion of
multiple reset controls, I wonder if this would be useful to add.
Without having thought about this too hard, I could imagine this as an
extension to the bulk API, or possibly a call to join multiple reset
controls into a reset control array.
> +static void rockchip_snd_reset(struct reset_control *rc)
> +{
> + if (IS_ERR(rc))
> + return;
This shouldn't be called with an error code, see the comment about
optional reset controls below.
> +
> + reset_control_assert(rc);
> + udelay(1);
What is the reason for the different delays in
rockchip_snd_xfer_sync_reset() and rockchip_snd_reset()?
> + reset_control_deassert(rc);
> +}
[...]
> +static int rockchip_i2s_tdm_probe(struct platform_device *pdev)
> +{
> + struct device_node *node = pdev->dev.of_node;
> + struct device_node *cru_node;
> + const struct of_device_id *of_id;
> + struct rk_i2s_tdm_dev *i2s_tdm;
> + struct resource *res;
> + void __iomem *regs;
> + int ret;
> + int val;
> +
> + i2s_tdm = devm_kzalloc(&pdev->dev, sizeof(*i2s_tdm), GFP_KERNEL);
> + if (!i2s_tdm)
> + return -ENOMEM;
> +
> + i2s_tdm->dev = &pdev->dev;
> +
> + of_id = of_match_device(rockchip_i2s_tdm_match, &pdev->dev);
> + if (!of_id || !of_id->data)
> + return -EINVAL;
> +
> + spin_lock_init(&i2s_tdm->lock);
> + i2s_tdm->soc_data = (struct rk_i2s_soc_data *)of_id->data;
> +
> + i2s_tdm->frame_width = 64;
> + if (!of_property_read_u32(node, "rockchip,frame-width", &val)) {
> + if (val >= 32 && (val % 2 == 0) && val <= 512) {
> + i2s_tdm->frame_width = val;
> + } else {
> + dev_err(i2s_tdm->dev, "unsupported frame width: '%d'\n",
> + val);
> + return -EINVAL;
> + }
> + }
> +
> + i2s_tdm->clk_trcm = TRCM_TXRX;
> + if (of_property_read_bool(node, "rockchip,trcm-sync-tx-only"))
> + i2s_tdm->clk_trcm = TRCM_TX;
> + if (of_property_read_bool(node, "rockchip,trcm-sync-rx-only")) {
> + if (i2s_tdm->clk_trcm) {
> + dev_err(i2s_tdm->dev, "invalid trcm-sync configuration\n");
> + return -EINVAL;
> + }
> + i2s_tdm->clk_trcm = TRCM_RX;
> + }
> + if (i2s_tdm->clk_trcm != TRCM_TXRX)
> + i2s_tdm_dai.symmetric_rate = 1;
> +
> + i2s_tdm->tdm_fsync_half_frame =
> + of_property_read_bool(node, "rockchip,tdm-fsync-half-frame");
> +
> + i2s_tdm->grf = syscon_regmap_lookup_by_phandle(node, "rockchip,grf");
> + if (IS_ERR(i2s_tdm->grf))
> + return dev_err_probe(i2s_tdm->dev, PTR_ERR(i2s_tdm->grf),
> + "Error in rockchip,grf\n");
> +
> + if (i2s_tdm->clk_trcm != TRCM_TXRX) {
> + cru_node = of_parse_phandle(node, "rockchip,cru", 0);
> + i2s_tdm->cru_base = of_iomap(cru_node, 0);
This is a bit ugly if there is another driver sitting on the
rockchip,cru compatible node. Which reset controller driver is backing
the reset controls below?
> + of_node_put(cru_node);
> + if (!i2s_tdm->cru_base) {
> + dev_err(i2s_tdm->dev,
> + "Missing or unsupported rockchip,cru node\n");
> + return -ENOENT;
> + }
> +
> + i2s_tdm->tx_reset_id = of_i2s_resetid_get(node, "tx-m");
> + i2s_tdm->rx_reset_id = of_i2s_resetid_get(node, "rx-m");
> + }
> +
> + i2s_tdm->tx_reset = devm_reset_control_get(&pdev->dev, "tx-m");
Please use devm_reset_control_get_exclusive() instead.
> + if (IS_ERR(i2s_tdm->tx_reset)) {
> + ret = PTR_ERR(i2s_tdm->tx_reset);
> + if (ret != -ENOENT)
> + return dev_err_probe(i2s_tdm->dev, ret,
> + "Error in tx-m reset control\n");
> + }
> +
> + i2s_tdm->rx_reset = devm_reset_control_get(&pdev->dev, "rx-m");
> + if (IS_ERR(i2s_tdm->rx_reset)) {
> + ret = PTR_ERR(i2s_tdm->rx_reset);
> + if (ret != -ENOENT)
Why is -ENOENT acceptable? If you want these to be optional, use
devm_reset_control_get_optional_exclusive() [1] instead. That will
return NULL if the reset is not specified in the device tree, which will
be ignored by reset_control_(de)assert().
[1] https://www.kernel.org/doc/html/latest/driver-api/reset.html#c.devm_reset_control_get_optional_exclusive
> + return dev_err_probe(i2s_tdm->dev, ret,
> + "Error in rx-m reset control\n");
> + }
> +
> + i2s_tdm->hclk = devm_clk_get(&pdev->dev, "hclk");
> + if (IS_ERR(i2s_tdm->hclk)) {
> + return dev_err_probe(i2s_tdm->dev, PTR_ERR(i2s_tdm->hclk),
> + "Failed to get clock hclk\n");
> + }
> +
> + ret = clk_prepare_enable(i2s_tdm->hclk);
> + if (ret) {
> + return dev_err_probe(i2s_tdm->dev, ret,
> + "Failed to enable clock hclk\n");
> + }
This clock is left enabled in all the error paths below. You could
install a cleanup action with devm_add_action_or_reset(), or better
start enabling the hardware only after acquisition of all required
resources has succeeded.
[...]
> +static int rockchip_i2s_tdm_remove(struct platform_device *pdev)
> +{
> + struct rk_i2s_tdm_dev *i2s_tdm = dev_get_drvdata(&pdev->dev);
> +
> + pm_runtime_disable(&pdev->dev);
> + if (!pm_runtime_status_suspended(&pdev->dev))
> + i2s_tdm_runtime_suspend(&pdev->dev);
> +
> + if (!IS_ERR(i2s_tdm->mclk_tx))
> + clk_prepare_enable(i2s_tdm->mclk_tx);
> + if (!IS_ERR(i2s_tdm->mclk_rx))
> + clk_prepare_enable(i2s_tdm->mclk_rx);
Why are we enabling these clocks now?
> + if (!IS_ERR(i2s_tdm->hclk))
> + clk_disable_unprepare(i2s_tdm->hclk);
> +
> + return 0;
> +}
regards
Philipp
More information about the linux-arm-kernel
mailing list