[PATCH net-next 1/3] dt-bindings: net: fsl, fec: add "fsl, wakeup-irq" property

[Andrew Lunn]

> > > 1) FEC controller has up to 4 interrupt lines and all of these are routed to GIC
> > interrupt controller.
> > > 2) FEC has a wakeup interrupt signal and always are mixed with other
> > interrupt signals, and then output to one interrupt line.
> > > 3) For legacy SoCs, wakeup interrupt are mixed to int0 line, but for i.MX8M
> > serials, are mixed to int2 line.

So you need to know which of the interrupts listed is the wake up
interrupt.

I can see a few ways to do this:

The FEC driver already has quirks. Add a quirk to fec_imx8mq_info and
fec_imx8qm_info to indicate these should use int2.

or

Documentation/devicetree/bindings/interrupt-controller/interrupts.txt 

  b) two cells
  ------------
  The #interrupt-cells property is set to 2 and the first cell defines the
  index of the interrupt within the controller, while the second cell is used
  to specify any of the following flags:
    - bits[3:0] trigger type and level flags
        1 = low-to-high edge triggered
        2 = high-to-low edge triggered
        4 = active high level-sensitive
        8 = active low level-sensitive

You could add

       18 = wakeup source

and extend to core to either do all the work for you, or tell you this
interrupt is flagged as being a wakeup source. This solution has the
advantage of it should be usable in other drivers.

	  Andrew