[PATCH 8/8] cpufreq: vexpress: Use auto-registration for energy model

[Lukasz Luba]

On 8/10/21 8:36 AM, Viresh Kumar wrote:
> Use the CPUFREQ_REGISTER_WITH_EM flag to allow cpufreq core to
> automatically register with the energy model.
> 
> This allows removal of boiler plate code from the driver and fixes the
> unregistration part as well.
> 
> Signed-off-by: Viresh Kumar <viresh.kumar at linaro.org>
> ---
>   drivers/cpufreq/vexpress-spc-cpufreq.c | 5 ++---
>   1 file changed, 2 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/cpufreq/vexpress-spc-cpufreq.c b/drivers/cpufreq/vexpress-spc-cpufreq.c
> index 51dfa9ae6cf5..28c4c3254337 100644
> --- a/drivers/cpufreq/vexpress-spc-cpufreq.c
> +++ b/drivers/cpufreq/vexpress-spc-cpufreq.c
> @@ -442,8 +442,6 @@ static int ve_spc_cpufreq_init(struct cpufreq_policy *policy)
>   	policy->freq_table = freq_table[cur_cluster];
>   	policy->cpuinfo.transition_latency = 1000000; /* 1 ms */
>   
> -	dev_pm_opp_of_register_em(cpu_dev, policy->cpus);
> -
>   	if (is_bL_switching_enabled())
>   		per_cpu(cpu_last_req_freq, policy->cpu) =
>   						clk_get_cpu_rate(policy->cpu);
> @@ -487,7 +485,8 @@ static void ve_spc_cpufreq_ready(struct cpufreq_policy *policy)
>   static struct cpufreq_driver ve_spc_cpufreq_driver = {
>   	.name			= "vexpress-spc",
>   	.flags			= CPUFREQ_HAVE_GOVERNOR_PER_POLICY |
> -					CPUFREQ_NEED_INITIAL_FREQ_CHECK,
> +				  CPUFREQ_NEED_INITIAL_FREQ_CHECK |
> +				  CPUFREQ_REGISTER_WITH_EM,
>   	.verify			= cpufreq_generic_frequency_table_verify,
>   	.target_index		= ve_spc_cpufreq_set_target,
>   	.get			= ve_spc_cpufreq_get_rate,
> 

With the change for patch 1/8 the we discussed below this patch 8/8,
it LGTM

Reviewed-by: Lukasz Luba <lukasz.luba at arm.com>