[PATCH v2 1/2] dt-bindings: usb: Document the Allwinner H6 DWC3 glue

[Rob Herring]

On Thu, 29 Apr 2021 22:19:11 -0500, Samuel Holland wrote:
> The RST_BUS_XHCI reset line in the H6 affects both the DWC3 core and the
> USB3 PHY. This suggests the reset line controls the USB3 IP as a whole.
> Represent this by attaching the reset line to a glue layer device.
> 
> Signed-off-by: Samuel Holland <samuel at sholland.org>
> ---
>  .../usb/allwinner,sun50i-h6-dwc3.yaml         | 75 +++++++++++++++++++
>  1 file changed, 75 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/usb/allwinner,sun50i-h6-dwc3.yaml
> 

My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
on your patch (DT_CHECKER_FLAGS is new in v5.13):

yamllint warnings/errors:

dtschema/dtc warnings/errors:
Documentation/devicetree/bindings/usb/allwinner,sun50i-h6-dwc3.example.dts:23.27-50.11: Warning (unit_address_vs_reg): /example-0/usb at 5200000: node has a unit name, but no reg or ranges property
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/usb/allwinner,sun50i-h6-dwc3.example.dt.yaml: usb at 5200000: usb at 5200000:phy-names:0: 'usb2-phy' was expected
	From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/usb/allwinner,sun50i-h6-dwc3.yaml
/builds/robherring/linux-dt-review/Documentation/devicetree/bindings/usb/allwinner,sun50i-h6-dwc3.example.dt.yaml: usb at 5200000: phy-names:0: 'usb2-phy' was expected
	From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/usb/snps,dwc3.yaml

See https://patchwork.ozlabs.org/patch/1471948

This check can fail if there are any dependencies. The base for a patch
series is generally the most recent rc1.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit.