[PATCH 4/5] ARM: dts: gose: Configure pull-up for SOFT_SW GPIO keys

[Geert Uytterhoeven]

The GPIO pins connected to the 4 Software Switches ("SOFT_SW", SW2) do
not have external pull-up resistors, but rely on internal pull-ups being
enabled.  Fortunately this is satisfied by the initial state of these
pins.

Make this explicit by enabling bias-pull-up, to remove the dependency on
initial state and/or boot loader configuration.

While at it, rename the surrounding device node from "gpio-keys" to
"keyboard", to comply with generic node name recommendations.

Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
---
 arch/arm/boot/dts/r8a7793-gose.dts | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/r8a7793-gose.dts b/arch/arm/boot/dts/r8a7793-gose.dts
index 87fa57a99399b73d..479e0fdf0c37311e 100644
--- a/arch/arm/boot/dts/r8a7793-gose.dts
+++ b/arch/arm/boot/dts/r8a7793-gose.dts
@@ -64,9 +64,12 @@ memory at 40000000 {
 		reg = <0 0x40000000 0 0x40000000>;
 	};
 
-	gpio-keys {
+	keyboard {
 		compatible = "gpio-keys";
 
+		pinctrl-0 = <&keyboard_pins>;
+		pinctrl-names = "default";
+
 		key-1 {
 			gpios = <&gpio5 0 GPIO_ACTIVE_LOW>;
 			linux,code = <KEY_1>;
@@ -567,6 +570,11 @@ sound_clk_pins: sound_clk {
 		function = "audio_clk";
 	};
 
+	keyboard_pins: keyboard {
+		pins = "GP_5_0", "GP_5_1", "GP_5_2", "GP_5_3";
+		bias-pull-up;
+	};
+
 	vin0_pins: vin0 {
 		groups = "vin0_data24", "vin0_sync", "vin0_clkenb", "vin0_clk";
 		function = "vin0";
-- 
2.25.1