[PATCH 16/16] soc: imx: gpcv2: remove waiting handshake in power up

[Lucas Stach]

Am Freitag, dem 30.04.2021 um 15:14 +0800 schrieb Peng Fan (OSS):
> 
> On 2021/4/29 22:34, Lucas Stach wrote:
> > Am Donnerstag, dem 29.04.2021 um 15:30 +0800 schrieb Peng Fan (OSS):
> > > From: Peng Fan <peng.fan at nxp.com>
> > > 
> > > i.MX8MM has blk ctl module, the handshake can only finish after setting
> > > blk ctl. The blk ctl driver will set the bus clk bit and the handshake
> > > will finish there. we just add a delay and suppose the handshake will
> > > finish after that.
> > 
> > Instead of this patch, just drop patch 05/16 from this series. I think
> > we should leave a comment in the code on why we aren't waiting for the
> > handshake ack, as this is non-obvious from looking at the driver code.
> > 
> > Basically add a polished version of the commit log from this patch into
> > the driver code.
> 
> After thinking more, for power down, we need wait handshake. For power 
> up, we could ignore handshake, because BLK-CTL setting bus clk en
> will auto trigger handshake.
> 
> For power down, the bus clk en already set, and we need wait, otherwise
> we need add delay there.
> 
> So I would only drop the power up waiting and add some comments there.

Ah, right. This way makes a lot of sense.

Regards,
Lucas