[PATCH V9 1/2] watchdog: mtk: support pre-timeout when the bark irq is available

Guenter Roeck linux at roeck-us.net
Thu Apr 29 23:22:57 BST 2021


On 4/24/21 6:52 PM, Wang Qing wrote:
> Use the bark interrupt as the pretimeout notifier if available.
> 
> When the watchdog timer expires in dual mode, an interrupt will be
> triggered first, then the timing restarts. The reset signal will be
> initiated when the timer expires again.
> 
> The pretimeout notification shall occur at timeout-sec/2.
> 
> V2:
> - panic() by default if WATCHDOG_PRETIMEOUT_GOV is not enabled.
> 
> V3:
> - Modify the pretimeout behavior, manually reset after the pretimeout
> - is processed and wait until timeout.
> 
> V4:
> - Remove pretimeout related processing. 
> - Add dual mode control separately.
> 
> V5:
> - Fix some formatting and printing problems.
> 
> V6:
> - Realize pretimeout processing through dualmode.
> 
> V7:
> - Add set_pretimeout().
> 
> V8/V9:
> - Fix some formatting problems.
> 
> Signed-off-by: Wang Qing <wangqing at vivo.com>

Reviewed-by: Guenter Roeck <linux at roeck-us.net>

Note that the version history should be after "---".

Guenter

> ---
>  drivers/watchdog/mtk_wdt.c | 77 +++++++++++++++++++++++++++++++++++++++++++---
>  1 file changed, 72 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/watchdog/mtk_wdt.c b/drivers/watchdog/mtk_wdt.c
> index 97ca993..7bb0774
> --- a/drivers/watchdog/mtk_wdt.c
> +++ b/drivers/watchdog/mtk_wdt.c
> @@ -25,9 +25,10 @@
>  #include <linux/reset-controller.h>
>  #include <linux/types.h>
>  #include <linux/watchdog.h>
> +#include <linux/interrupt.h>
>  
>  #define WDT_MAX_TIMEOUT		31
> -#define WDT_MIN_TIMEOUT		1
> +#define WDT_MIN_TIMEOUT		2
>  #define WDT_LENGTH_TIMEOUT(n)	((n) << 5)
>  
>  #define WDT_LENGTH		0x04
> @@ -187,12 +188,19 @@ static int mtk_wdt_set_timeout(struct watchdog_device *wdt_dev,
>  	u32 reg;
>  
>  	wdt_dev->timeout = timeout;
> +	/*
> +	 * In dual mode, irq will be triggered at timeout / 2
> +	 * the real timeout occurs at timeout
> +	 */
> +	if (wdt_dev->pretimeout)
> +		wdt_dev->pretimeout = timeout / 2;
>  
>  	/*
>  	 * One bit is the value of 512 ticks
>  	 * The clock has 32 KHz
>  	 */
> -	reg = WDT_LENGTH_TIMEOUT(timeout << 6) | WDT_LENGTH_KEY;
> +	reg = WDT_LENGTH_TIMEOUT((timeout - wdt_dev->pretimeout) << 6)
> +			| WDT_LENGTH_KEY;
>  	iowrite32(reg, wdt_base + WDT_LENGTH);
>  
>  	mtk_wdt_ping(wdt_dev);
> @@ -239,13 +247,48 @@ static int mtk_wdt_start(struct watchdog_device *wdt_dev)
>  		return ret;
>  
>  	reg = ioread32(wdt_base + WDT_MODE);
> -	reg &= ~(WDT_MODE_IRQ_EN | WDT_MODE_DUAL_EN);
> +	if (wdt_dev->pretimeout)
> +		reg |= (WDT_MODE_IRQ_EN | WDT_MODE_DUAL_EN);
> +	else
> +		reg &= ~(WDT_MODE_IRQ_EN | WDT_MODE_DUAL_EN);
>  	reg |= (WDT_MODE_EN | WDT_MODE_KEY);
>  	iowrite32(reg, wdt_base + WDT_MODE);
>  
>  	return 0;
>  }
>  
> +static int mtk_wdt_set_pretimeout(struct watchdog_device *wdd,
> +				  unsigned int timeout)
> +{
> +	struct mtk_wdt_dev *mtk_wdt = watchdog_get_drvdata(wdd);
> +	void __iomem *wdt_base = mtk_wdt->wdt_base;
> +	u32 reg = ioread32(wdt_base + WDT_MODE);
> +
> +	if (timeout && !wdd->pretimeout) {
> +		wdd->pretimeout = wdd->timeout / 2;
> +		reg |= (WDT_MODE_IRQ_EN | WDT_MODE_DUAL_EN);
> +	} else if (!timeout && wdd->pretimeout) {
> +		wdd->pretimeout = 0;
> +		reg &= ~(WDT_MODE_IRQ_EN | WDT_MODE_DUAL_EN);
> +	} else {
> +		return 0;
> +	}
> +
> +	reg |= WDT_MODE_KEY;
> +	iowrite32(reg, wdt_base + WDT_MODE);
> +
> +	return mtk_wdt_set_timeout(wdd, wdd->timeout);
> +}
> +
> +static irqreturn_t mtk_wdt_isr(int irq, void *arg)
> +{
> +	struct watchdog_device *wdd = arg;
> +
> +	watchdog_notify_pretimeout(wdd);
> +
> +	return IRQ_HANDLED;
> +}
> +
>  static const struct watchdog_info mtk_wdt_info = {
>  	.identity	= DRV_NAME,
>  	.options	= WDIOF_SETTIMEOUT |
> @@ -253,12 +296,21 @@ static const struct watchdog_info mtk_wdt_info = {
>  			  WDIOF_MAGICCLOSE,
>  };
>  
> +static const struct watchdog_info mtk_wdt_pt_info = {
> +	.identity	= DRV_NAME,
> +	.options	= WDIOF_SETTIMEOUT |
> +			  WDIOF_PRETIMEOUT |
> +			  WDIOF_KEEPALIVEPING |
> +			  WDIOF_MAGICCLOSE,
> +};
> +
>  static const struct watchdog_ops mtk_wdt_ops = {
>  	.owner		= THIS_MODULE,
>  	.start		= mtk_wdt_start,
>  	.stop		= mtk_wdt_stop,
>  	.ping		= mtk_wdt_ping,
>  	.set_timeout	= mtk_wdt_set_timeout,
> +	.set_pretimeout	= mtk_wdt_set_pretimeout,
>  	.restart	= mtk_wdt_restart,
>  };
>  
> @@ -267,7 +319,7 @@ static int mtk_wdt_probe(struct platform_device *pdev)
>  	struct device *dev = &pdev->dev;
>  	struct mtk_wdt_dev *mtk_wdt;
>  	const struct mtk_wdt_data *wdt_data;
> -	int err;
> +	int err, irq;
>  
>  	mtk_wdt = devm_kzalloc(dev, sizeof(*mtk_wdt), GFP_KERNEL);
>  	if (!mtk_wdt)
> @@ -279,7 +331,22 @@ static int mtk_wdt_probe(struct platform_device *pdev)
>  	if (IS_ERR(mtk_wdt->wdt_base))
>  		return PTR_ERR(mtk_wdt->wdt_base);
>  
> -	mtk_wdt->wdt_dev.info = &mtk_wdt_info;
> +	irq = platform_get_irq(pdev, 0);
> +	if (irq > 0) {
> +		err = devm_request_irq(&pdev->dev, irq, mtk_wdt_isr, 0, "wdt_bark",
> +				       &mtk_wdt->wdt_dev);
> +		if (err)
> +			return err;
> +
> +		mtk_wdt->wdt_dev.info = &mtk_wdt_pt_info;
> +		mtk_wdt->wdt_dev.pretimeout = WDT_MAX_TIMEOUT / 2;
> +	} else {
> +		if (irq == -EPROBE_DEFER)
> +			return -EPROBE_DEFER;
> +
> +		mtk_wdt->wdt_dev.info = &mtk_wdt_info;
> +	}
> +
>  	mtk_wdt->wdt_dev.ops = &mtk_wdt_ops;
>  	mtk_wdt->wdt_dev.timeout = WDT_MAX_TIMEOUT;
>  	mtk_wdt->wdt_dev.max_hw_heartbeat_ms = WDT_MAX_TIMEOUT * 1000;
> 




More information about the linux-arm-kernel mailing list