[PATCH 16/16] soc: imx: gpcv2: remove waiting handshake in power up

[Lucas Stach]

Am Donnerstag, dem 29.04.2021 um 15:30 +0800 schrieb Peng Fan (OSS):
> From: Peng Fan <peng.fan at nxp.com>
> 
> i.MX8MM has blk ctl module, the handshake can only finish after setting
> blk ctl. The blk ctl driver will set the bus clk bit and the handshake
> will finish there. we just add a delay and suppose the handshake will
> finish after that.

Instead of this patch, just drop patch 05/16 from this series. I think
we should leave a comment in the code on why we aren't waiting for the
handshake ack, as this is non-obvious from looking at the driver code. 

Basically add a polished version of the commit log from this patch into
the driver code.

Regards,
Lucas

> Signed-off-by: Peng Fan <peng.fan at nxp.com>
> ---
>  drivers/soc/imx/gpcv2.c | 8 --------
>  1 file changed, 8 deletions(-)
> 
> diff --git a/drivers/soc/imx/gpcv2.c b/drivers/soc/imx/gpcv2.c
> index 49dd137f6b94..04564017bfe9 100644
> --- a/drivers/soc/imx/gpcv2.c
> +++ b/drivers/soc/imx/gpcv2.c
> @@ -251,14 +251,6 @@ static int imx_pgc_power_up(struct generic_pm_domain *genpd)
>  		regmap_update_bits(domain->regmap, GPC_PU_PWRHSK,
>  				   domain->bits.hskreq, domain->bits.hskreq);
>  
> 
> 
> 
> -		ret = regmap_read_poll_timeout(domain->regmap, GPC_PU_PWRHSK,
> -					       reg_val,
> -					       (reg_val & domain->bits.hskack),
> -					       0, USEC_PER_MSEC);
> -		if (ret) {
> -			dev_err(domain->dev, "failed to power up ADB400\n");
> -			goto out_clk_disable;
> -		}
>  	}
>  
> 
> 
> 
>  	/* Disable reset clocks for all devices in the domain */