[PATCH net-next 0/5] Flow control for NXP ENETC

[Vladimir Oltean]

From: Vladimir Oltean <vladimir.oltean at nxp.com>

This patch series contains logic for enabling the lossless mode on the
RX rings of the ENETC, and the PAUSE thresholds on the internal FIFO
memory.

During testing it was found that, with the default FIFO configuration,
a sender which isn't persuaded by our PAUSE frames and keeps sending
will cause some MAC RX frame errors. To mitigate this, we need to ensure
that the FIFO never runs completely full, so we need to fix up a setting
that was supposed to be configured well out of reset. Unfortunately this
requires the addition of a new mini-driver.

Vladimir Oltean (5):
  net: enetc: create a common enetc_pf_to_port helper
  dt-bindings: net: fsl: enetc: add the IERB documentation
  net: enetc: add a mini driver for the Integrated Endpoint Register
    Block
  arm64: dts: ls1028a: declare the Integrated Endpoint Register Block
    node
  net: enetc: add support for flow control

 .../devicetree/bindings/net/fsl-enetc.txt     |  15 ++
 .../arm64/boot/dts/freescale/fsl-ls1028a.dtsi |   6 +
 drivers/net/ethernet/freescale/enetc/Kconfig  |   9 +
 drivers/net/ethernet/freescale/enetc/Makefile |   3 +
 drivers/net/ethernet/freescale/enetc/enetc.h  |  16 ++
 .../ethernet/freescale/enetc/enetc_ethtool.c  |  18 ++
 .../net/ethernet/freescale/enetc/enetc_hw.h   |   9 +
 .../net/ethernet/freescale/enetc/enetc_ierb.c | 155 ++++++++++++++++++
 .../net/ethernet/freescale/enetc/enetc_ierb.h |  20 +++
 .../net/ethernet/freescale/enetc/enetc_pf.c   |  95 ++++++++++-
 .../net/ethernet/freescale/enetc/enetc_qos.c  |  16 +-
 11 files changed, 349 insertions(+), 13 deletions(-)
 create mode 100644 drivers/net/ethernet/freescale/enetc/enetc_ierb.c
 create mode 100644 drivers/net/ethernet/freescale/enetc/enetc_ierb.h

-- 
2.25.1