[PATCH 1/1] arm64: dts: mt8183-kukui: Enable thermal Tboard
Hsin-Yi Wang
hsinyi at chromium.org
Fri Apr 9 08:16:44 BST 2021
On Fri, Apr 9, 2021 at 3:12 PM Michael Kao <michael.kao at mediatek.com> wrote:
>
> Add Tboard thermal sensor settings.
>
> pull-up voltage: 1800 mv
> pull-up resistor: 75K
>
> Vsense = pull-up voltage * Rntc / ( pull-up resistor + Rntc )
> AuxIn = Vsense * 4096 / 1500
>
> TEST=boot kukui
> check /sys/class/thermal/thermal_zone*/type
> check /sys/class/thermal/thermal_zone*/temp
the TEST lines can be removed.
>
> Signed-off-by: Michael Kao <michael.kao at mediatek.com>
> Signed-off-by: Nicolas Boichat <drinkcat at chromium.org>
> ---
Tested-by: Hsin-Yi Wang <hsinyi at chromium.org>
This removes following error:
[ 10.882325] generic-adc-thermal thermal-sensor1: Thermal zone
sensor register failed: -19
[ 10.911912] generic-adc-thermal thermal-sensor2: Thermal zone
sensor register failed: -19
> arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi | 14 ++++++++++++++
> arch/arm64/boot/dts/mediatek/mt8183.dtsi | 2 +-
> 2 files changed, 15 insertions(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi b/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> index bf2ad1294dd3..202acb542b12 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> +++ b/arch/arm64/boot/dts/mediatek/mt8183-kukui.dtsi
> @@ -801,6 +801,20 @@
> status = "okay";
> };
>
> +&thermal_zones {
> + Tboard1 {
> + polling-delay = <1000>; /* milliseconds */
> + polling-delay-passive = <0>; /* milliseconds */
> + thermal-sensors = <&tboard_thermistor1>;
> + };
> +
> + Tboard2 {
> + polling-delay = <1000>; /* milliseconds */
> + polling-delay-passive = <0>; /* milliseconds */
> + thermal-sensors = <&tboard_thermistor2>;
> + };
> +};
> +
> &u3phy {
> status = "okay";
> };
> diff --git a/arch/arm64/boot/dts/mediatek/mt8183.dtsi b/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> index 1ad0a1d55d53..f0719dbef249 100644
> --- a/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> +++ b/arch/arm64/boot/dts/mediatek/mt8183.dtsi
> @@ -673,7 +673,7 @@
> nvmem-cell-names = "calibration-data";
> };
>
> - thermal-zones {
> + thermal_zones: thermal-zones {
> cpu_thermal: cpu_thermal {
> polling-delay-passive = <100>;
> polling-delay = <500>;
> --
> 2.18.0
>
More information about the linux-arm-kernel
mailing list