[PATCH v4 2/6] dt-bindings: PCI: Add bindings for Brcmstb endpoint device voltage regulators

[Jim Quinlan]

On Thu, Apr 8, 2021 at 12:20 PM Rob Herring <robh at kernel.org> wrote:
>
> On Tue, Apr 06, 2021 at 02:25:49PM -0400, Jim Quinlan wrote:
> > On Tue, Apr 6, 2021 at 1:32 PM Mark Brown <broonie at kernel.org> wrote:
> > >
> > > On Tue, Apr 06, 2021 at 01:26:51PM -0400, Jim Quinlan wrote:
> > > > On Tue, Apr 6, 2021 at 12:47 PM Mark Brown <broonie at kernel.org> wrote:
> > >
> > > > > No great problem with having these in the controller node (assming it
> > > > > accurately describes the hardware) but I do think we ought to also be
> > > > > able to describe these per slot.
>
> PCIe is effectively point to point, so there's only 1 slot unless
> there's a PCIe switch in the middle. If that's the case, then it's all
> more complicated.
>
> > > > Can you explain what you think that would look like in the DT?
> > >
> > > I *think* that's just some properties on the nodes for the endpoints,
> > > note that the driver could just ignore them for now.  Not sure where or
> > > if we document any extensions but child nodes are in section 4 of the
> > > v2.1 PCI bus binding.
> >
> > Hi Mark,
> >
> > I'm a little confused -- here is how I remember the chronology of the
> > "DT bindings" commit reviews, please correct me if I'm wrong:
> >
> > o JimQ submitted a pullreq for using voltage regulators in the same
> > style as the existing "rockport" PCIe driver.
> > o After some deliberation, RobH preferred that the voltage regulators
> > should go into the PCIe subnode device's DT node.
>
> IIRC, that's because you said there isn't a standard slot.
Admittedly, I'm not exactly sure what you mean by a "standard slot".
Our PCIIe HW does not support  hotplug or have a presence bit or
anything like that.  Our root complex has one port; it can only
directly connect to a single switch or endpoint. This connection shows
up as slot0.  The voltage regulator(s) involved depend on a GPIO that
turns the power  on/off for the connected device/chip.  The gpio pin
can vary from board to board but this is easily handled in our DT.
Some boards have regulators that are always on and not associated with
a GPIO pin -- these have no representation in our DT.

Regards,
Jim


>
> > o JimQ put the voltage regulators in the subnode device's DT node.
> > o MarkB didn't like the fact that the code did a global search for the
> > regulator since it could not provide the owning struct device* handle.
> > o RobH relented, and said that if it is just two specific and standard
> > voltage regulators, perhaps they can go in the parent DT node after
> > all.
> > o JimQ put the regulators back in the PCIe node.
> > o MarkB now wants the regulators to go back into the child node again?
> >
> > Folks, please advise.
> >
> > Regards,
> > Jim Quinlan
> > Broadcom STB