[PATCH 1/2] arm64: dts: ls1028a: fix memory node

Michael Walle michael at walle.cc
Thu Apr 8 12:02:18 BST 2021


While enabling EDAC support for the LS1028A it was discovered that the
memory node has a wrong endianness setting as well as a wrong interrupt
assignment. Fix both.

This was tested on a sl28 board. To force ECC errors, you can use the
error injection supported by the controller in hardware (with
CONFIG_EDAC_DEBUG enabled):

 # enable error injection
 $ echo 0x100 > /sys/devices/system/edac/mc/mc0/inject_ctrl
 # flip lowest bit of the data
 $ echo 0x1 > /sys/devices/system/edac/mc/mc0/inject_data_lo

Fixes: 8897f3255c9c ("arm64: dts: Add support for NXP LS1028A SoC")
Signed-off-by: Michael Walle <michael at walle.cc>
---
 arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
index 9506f0669ead..040a3e529bf1 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
@@ -197,8 +197,8 @@
 		ddr: memory-controller at 1080000 {
 			compatible = "fsl,qoriq-memory-controller";
 			reg = <0x0 0x1080000 0x0 0x1000>;
-			interrupts = <GIC_SPI 144 IRQ_TYPE_LEVEL_HIGH>;
-			big-endian;
+			interrupts = <GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>;
+			little-endian;
 		};
 
 		dcfg: syscon at 1e00000 {
-- 
2.20.1




More information about the linux-arm-kernel mailing list