[PATCH v2 2/2] arm: zynq: don't disable CONFIG_ARM_GLOBAL_TIMER due to CONFIG_CPU_FREQ anymore
Andrea Merello
andrea.merello at gmail.com
Tue Apr 6 14:00:45 BST 2021
Now ARM global timer driver could work even if it's source clock rate
changes, so we don't need to disable that driver when cpu frequency scaling
is in use.
This cause Zynq arch to get support for timer delay and get_cycles().
Signed-off-by: Andrea Merello <andrea.merello at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: linux-kernel at vger.kernel.org
Cc: linux-arm-kernel at lists.infradead.org
Cc: Michal Simek <michal.simek at xilinx.com>
Cc: Sören Brinkmann <soren.brinkmann at xilinx.com>
---
arch/arm/mach-zynq/Kconfig | 2 +-
drivers/clocksource/Kconfig | 1 +
2 files changed, 2 insertions(+), 1 deletion(-)
diff --git a/arch/arm/mach-zynq/Kconfig b/arch/arm/mach-zynq/Kconfig
index 43fb941dcd07..a56748d671c4 100644
--- a/arch/arm/mach-zynq/Kconfig
+++ b/arch/arm/mach-zynq/Kconfig
@@ -6,7 +6,7 @@ config ARCH_ZYNQ
select ARCH_SUPPORTS_BIG_ENDIAN
select ARM_AMBA
select ARM_GIC
- select ARM_GLOBAL_TIMER if !CPU_FREQ
+ select ARM_GLOBAL_TIMER
select CADENCE_TTC_TIMER
select HAVE_ARM_SCU if SMP
select HAVE_ARM_TWD if SMP
diff --git a/drivers/clocksource/Kconfig b/drivers/clocksource/Kconfig
index 19fc5f8883e0..9fa28237715a 100644
--- a/drivers/clocksource/Kconfig
+++ b/drivers/clocksource/Kconfig
@@ -360,6 +360,7 @@ config ARM_GLOBAL_TIMER
config ARM_GT_INITIAL_PRESCALER_VAL
int "ARM global timer initial prescaler value"
+ default 2 if ARCH_ZYNQ
default 1
depends on ARM_GLOBAL_TIMER
help
--
2.17.1
More information about the linux-arm-kernel
mailing list