[PATCH 2/3] fpga: region: Add fpga-region property 'power-domains'
Nava kishore Manne
navam at xilinx.com
Mon Apr 5 09:46:51 BST 2021
Hi Moritz,
Thanks for the response.
Please find my response inline.
> -----Original Message-----
> From: Moritz Fischer <mdf at kernel.org>
> Sent: Friday, April 2, 2021 10:46 PM
> To: Nava kishore Manne <navam at xilinx.com>
> Cc: mdf at kernel.org; trix at redhat.com; robh+dt at kernel.org; Michal Simek
> <michals at xilinx.com>; linux-fpga at vger.kernel.org;
> devicetree at vger.kernel.org; linux-kernel at vger.kernel.org; linux-arm-
> kernel at lists.infradead.org; git <git at xilinx.com>
> Subject: Re: [PATCH 2/3] fpga: region: Add fpga-region property 'power-
> domains'
>
> On Fri, Apr 02, 2021 at 02:50:48PM +0530, Nava kishore Manne wrote:
> > Add fpga-region property 'power-domains' to allow to handle the
> > FPGA/PL power domins.
> >
> > dt-bindings: fpga: Enable PM generic domain support
> >
> > Signed-off-by: Nava kishore Manne <nava.manne at xilinx.com>
> > ---
> > .../devicetree/bindings/fpga/fpga-region.txt | 14 ++++++++++++++
> > 1 file changed, 14 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > b/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > index e811cf825019..969ca53bb65e 100644
> > --- a/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > +++ b/Documentation/devicetree/bindings/fpga/fpga-region.txt
> > @@ -196,6 +196,20 @@ Optional properties:
> > - config-complete-timeout-us : The maximum time in microseconds time
> for the
> > FPGA to go to operating mode after the region has been
> programmed.
> > - child nodes : devices in the FPGA after programming.
> > +- power-domains : A phandle and PM domain specifier as defined by
> bindings of
> > + the power controller specified by phandle.
> > +Example:
> > + fpga_full: fpga-full {
> > + compatible = "fpga-region";
> > + fpga-mgr = <&zynqmp_pcap>;
> > + #address-cells = <2>;
> > + #size-cells = <2>;
> > + ranges;
> > + power-domains = <&zynqmp_firmware PL_PD>;
> > + };
> > +
> > + The PL_PD power domain will be turned on before loading the
> > +bitstream and turned off while removing/unloading the bitstream using
> overlays.
>
> Can multiple regions share a power-domain or is this specific to full fpga
> reconfiguration?
>
These are generic changes and not limited to full region. If H/W supports individual power domains to control the Partial reconfiguration regions we can control the individual Partial reconfiguration region power domains as well.
Regards,
Navakishore.
More information about the linux-arm-kernel
mailing list