[PATCH 4/4] ARM: dts: Fix-up EMMC2 controller's frequency

[Nicolas Saenz Julienne]

Hi Alan,

On Thu, 2021-04-01 at 11:23 -0400, Alan Cooper wrote:
> Nicolas,
> 
> Sorry, I just noticed this thread.
> This is a known bug in some newer Arasan cores.
> The problem happens when the difference between the core clock and the bus
> clock is too great.
> Limiting the clock to 200KHz minimum should be a good fix.

Great, that's what I was hoping to hear :). Out of curiosity, can you share
more details on how the failure occurs?

> In my experience, it's only eMMC that needs the clock to be retried

> below 400KHz and not SD or SDIO. That's because the CMD signal for
> eMMC starts out as open-drain during identification and the size of
> the pull-up on the CMD signal can require the <400KHz clock. Once eMMC
> is out of identification mode the CMD signal is switched to push-pull
> and can run at much higher clock rates.

Fair enough, I need to do some tests, some of the compute modules use an eMMC.

> I don't think that SD and SDIO have any open-drain signals, so they
> shouldn't need to retry at slower clock speeds.

Noted.

> I'm trying to get more detail on the bug, like the exact ratio of core
> clock to bus clock that causes the problem. When I first found this
> bug I was told that the failure would not happen at 200KHz, but we
> were using a 405MHz core clock.

That would be nice to have.

> One other question. Why are you using polling for the SD card, this
> newer controller supports the interrupt driven "Card Inserted" signal
> and avoids wasting time polling?

I believe the line isn't routed on RPi4.

> Al

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 488 bytes
Desc: This is a digitally signed message part
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20210405/689a49fa/attachment-0001.sig>