[PATCH v4 05/18] dt-bindings: timer: arm, arch_timer: Add interrupt-names support

[Hector Martin]

Not all platforms provide the same set of timers/interrupts, and Linux
only needs one (plus kvm/guest ones); some platforms are working around
this by using dummy fake interrupts. Implementing interrupt-names allows
the devicetree to specify an arbitrary set of available interrupts, so
the timer code can pick the right one.

This also adds the hyp-virt timer/interrupt, which was previously not
expressed in the fixed 4-interrupt form.

Reviewed-by: Linus Walleij <linus.walleij at linaro.org>
Acked-by: Marc Zyngier <maz at kernel.org>
Reviewed-by: Tony Lindgren <tony at atomide.com>
Signed-off-by: Hector Martin <marcan at marcan.st>
---
 .../bindings/timer/arm,arch_timer.yaml        | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/Documentation/devicetree/bindings/timer/arm,arch_timer.yaml b/Documentation/devicetree/bindings/timer/arm,arch_timer.yaml
index 2c75105c1398..7f5e3af58255 100644
--- a/Documentation/devicetree/bindings/timer/arm,arch_timer.yaml
+++ b/Documentation/devicetree/bindings/timer/arm,arch_timer.yaml
@@ -34,11 +34,30 @@ properties:
               - arm,armv8-timer
 
   interrupts:
+    minItems: 1
+    maxItems: 5
     items:
       - description: secure timer irq
       - description: non-secure timer irq
       - description: virtual timer irq
       - description: hypervisor timer irq
+      - description: hypervisor virtual timer irq
+
+  interrupt-names:
+    oneOf:
+      - minItems: 2
+        items:
+          - const: phys
+          - const: virt
+          - const: hyp-phys
+          - const: hyp-virt
+      - minItems: 3
+        items:
+          - const: sec-phys
+          - const: phys
+          - const: virt
+          - const: hyp-phys
+          - const: hyp-virt
 
   clock-frequency:
     description: The frequency of the main counter, in Hz. Should be present
-- 
2.30.0