[PATCH v5 07/17] ARM: debug: add UART early console support for SD5203

[Wei Xu]

Hi Zhen Lei,

On 2020/9/29 22:14, Zhen Lei wrote:
> From: Kefeng Wang <wangkefeng.wang at huawei.com>
> 
> Add support of early console for SD5203.
> 
> Signed-off-by: Kefeng Wang <wangkefeng.wang at huawei.com>
> Signed-off-by: Zhen Lei <thunder.leizhen at huawei.com>

Thanks!
Applied to the hisilicon arm32 SoC tree.

Best Regards,
Wei

> ---
>  arch/arm/Kconfig.debug | 11 ++++++++++-
>  1 file changed, 10 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm/Kconfig.debug b/arch/arm/Kconfig.debug
> index 80000a66a4e3549..d27a7764c3bfb46 100644
> --- a/arch/arm/Kconfig.debug
> +++ b/arch/arm/Kconfig.debug
> @@ -1086,6 +1086,14 @@ choice
>  		  on SA-11x0 UART ports. The kernel will check for the first
>  		  enabled UART in a sequence 3-1-2.
>  
> +	config DEBUG_SD5203_UART
> +		bool "Hisilicon SD5203 Debug UART"
> +		depends on ARCH_SD5203
> +		select DEBUG_UART_8250
> +		help
> +		  Say Y here if you want kernel low-level debugging support
> +		  on SD5203 UART.
> +
>  	config DEBUG_SOCFPGA_UART0
>  		depends on ARCH_SOCFPGA
>  		bool "Use SOCFPGA UART0 for low-level debug"
> @@ -1639,6 +1647,7 @@ config DEBUG_UART_PHYS
>  	default 0x11006000 if DEBUG_MT6589_UART0
>  	default 0x11009000 if DEBUG_MT8135_UART3
>  	default 0x16000000 if DEBUG_INTEGRATOR
> +	default 0x1600d000 if DEBUG_SD5203_UART
>  	default 0x18000300 if DEBUG_BCM_5301X
>  	default 0x18000400 if DEBUG_BCM_HR2
>  	default 0x18010000 if DEBUG_SIRFATLAS7_UART0
> @@ -1841,7 +1850,7 @@ config DEBUG_UART_VIRT
>  	default 0xfec60000 if DEBUG_SIRFPRIMA2_UART1
>  	default 0xfec90000 if DEBUG_RK32_UART2
>  	default 0xfed0c000 if DEBUG_DAVINCI_DA8XX_UART1
> -	default 0xfed0d000 if DEBUG_DAVINCI_DA8XX_UART2
> +	default 0xfed0d000 if DEBUG_DAVINCI_DA8XX_UART2 || DEBUG_SD5203_UART
>  	default 0xfed60000 if DEBUG_RK29_UART0
>  	default 0xfed64000 if DEBUG_RK29_UART1 || DEBUG_RK3X_UART2
>  	default 0xfed68000 if DEBUG_RK29_UART2 || DEBUG_RK3X_UART3
>