[PATCH v4 1/4] dt-bindings: media: imx258: add bindings for IMX258 sensor

[Krzysztof Kozlowski]

On Tue, 29 Sep 2020 at 11:15, Sakari Ailus <sakari.ailus at linux.intel.com> wrote:
>
> Hi Krzysztof,
>
> On Wed, Sep 23, 2020 at 05:21:26PM +0200, Krzysztof Kozlowski wrote:
> > Add bindings for the IMX258 camera sensor.  The bindings, just like the
> > driver, are quite limited, e.g. do not support regulator supplies.
> >
> > Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> >
> > ---
> >
> > Changes since v3:
> > 1. Document also two lane setup.
> >
> > Changes since v2:
> > 1. Remove clock-frequency, add reset GPIOs, add supplies.
>
> Oops. I missed this one.
>
> How does the driver know the appropriate clock frequency for the platform
> if it's not in DT? The sensor supports a range of frequencies, not a single
> frequency.
>
> Could you add clock-frequency back?

Not really, it was removed on Rob's request. The bindings do not
describe driver's behavior so how the driver gets frequency should not
be part of the bindings. Also it's not a real problem - the driver
just calls clk_get_rate().

Best regards,
Krzysztof