[PATCH v2 7/7] arm64: dts: marvell: Add a device tree for the iEi Puzzle-M801 board

[Andrew Lunn]

On Sat, Sep 26, 2020 at 03:55:14PM +0200, Luka Kovacic wrote:
> Add initial support for the iEi Puzzle-M801 1U Rackmount Network
> Appliance board.
> 
> The board is based on the quad-core Marvell Armada 8040 SoC and supports
> up to 16 GB of DDR4 2400 MHz ECC RAM. It has a PCIe x16 slot (x2 lanes
> only) and an M.2 type B slot.
> 
> Main system hardware:
> 2x USB 3.0
> 4x Gigabit Ethernet
> 2x SFP+
> 1x SATA 3.0
> 1x M.2 type B
> 1x RJ45 UART
> 1x SPI flash
> 1x iEi WT61P803 PUZZLE Microcontroller
> 1x EPSON RX8010 RTC (used instead of the integrated Marvell RTC controller)
> 6x SFP+ LED
> 1x HDD LED
> 
> All of the hardware listed above is supported and tested in this port.
> 
> Signed-off-by: Luka Kovacic <luka.kovacic at sartura.hr>
> Cc: Luka Perkov <luka.perkov at sartura.hr>
> Cc: Robert Marko <robert.marko at sartura.hr>

I don't know this Marvell SoC too well, but what i see looks O.K.

Reviewed-by: Andrew Lunn <andrew at lunn.ch>

To get this merged, you probably need to break this patchset up and
send the DT part to Gregory. It could be Lee will take the rest if
there are ACKed by from the LED and HWMON maintainer.

    Andrew