[PATCH v2 0/2] Add support for MMC/SD on j7200-evm

[Vignesh Raghavendra]

On 9/24/20 4:56 PM, Faiz Abbas wrote:
> The following patches add dt support for MMC/SD on TI's j7200-evm.
> 
> Currently, eMMC support upto HS200 speed and SD card supports upto high
> speed speed mode.
> 
> v2:
> Fixed node names to use mmc@* format
> Fixed reg address format to align with others in the file
> 
> Faiz Abbas (2):
>   arm64: dts: ti: k3-j7200-main: Add support for MMC/SD controller nodes
>   arm64: dts: ti: k3-j7200-common-proc-board: Add support for eMMC and
>     SD card
> 
>  .../dts/ti/k3-j7200-common-proc-board.dts     | 28 ++++++++++++++
>  arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 37 +++++++++++++++++++
>  2 files changed, 65 insertions(+)
> 
For the series:

Tested-by: Vignesh Raghavendra <vigneshr at ti.com>


[    1.678263] mmc0: Command Queue Engine enabled
[    1.682727] mmc0: new HS200 MMC card at address 0001
[    1.688193] mmcblk0: mmc0:0001 S0J56X 14.8 GiB
[    1.692971] mmcblk0boot0: mmc0:0001 S0J56X partition 1 31.5 MiB
[    1.699138] mmcblk0boot1: mmc0:0001 S0J56X partition 2 31.5 MiB
[    1.705268] mmcblk0rpmb: mmc0:0001 S0J56X partition 3 4.00 MiB, ch
ardev (240:0)
[    1.789527] mmc1: new high speed SDHC card at address aaaa
[    1.795621] mmcblk1: mmc1:aaaa SC16G 14.8 GiB
[    1.810074]  mmcblk1: p1 p2


SD hot plug works fine too..
Full log: https://pastebin.ubuntu.com/p/5hcCQDjhtW/