[PATCH v2 05/10] pwm: ntxec: Add driver for PWM function in Netronix EC

[Lee Jones]

On Tue, 08 Sep 2020, Andy Shevchenko wrote:

> On Tue, Sep 8, 2020 at 11:14 AM Lee Jones <lee.jones at linaro.org> wrote:
> > On Sat, 05 Sep 2020, Andy Shevchenko wrote:
> > > On Saturday, September 5, 2020, Jonathan Neuschäfer <j.neuschaefer at gmx.net>
> > > wrote:
> 
> ...
> 
> > > > +config PWM_NTXEC
> > > > +       tristate "Netronix embedded controller PWM support"
> > >
> > >
> > >
> > >
> > > > +       depends on MFD_NTXEC && OF
> > >
> > >
> > > I don’t see need to reduce test coverage and use of the driver by sticking
> > > with OF. Actually it’s not used.
> >
> > If the device is only known to boot with OF, then it's pointless
> > building it when !OF.
> 
> No, it's not. As I pointed out the (compilation) test coverage is better.

No, it's a waste of disk space.

Why would you knowingly compile something you know you can't use?

That's the whole point of COMPILE_TEST.

Note that when you want real coverage and you use `allyesconfig`
and/or `allmodconfig` then CONFIG_OF is also enabled on platforms
which support it.

> > If you want to increase test coverage enable
> > COMPILE_TEST instead.
> 
> It is one way to achieve that, yes;
> 
>        depends on OF || COMPILE_TEST
>        depends on MFD_NTXEC

This is better.

-- 
Lee Jones [李琼斯]
Senior Technical Lead - Developer Services
Linaro.org │ Open source software for Arm SoCs
Follow Linaro: Facebook | Twitter | Blog