[PATCH 6/6] arm64: dts: ti: k3-j7200-common-proc-board: Add USB support

[Roger Quadros]

Enable USB0 port in high-speed (2.0) mode.

The board uses lane 3 of SERDES for USB. Set the mux
accordingly.

Signed-off-by: Roger Quadros <rogerq at ti.com>
---
 .../dts/ti/k3-j7200-common-proc-board.dts     | 22 +++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
index 0ecaba600704..f4b6a5abb1b5 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j7200-common-proc-board.dts
@@ -42,6 +42,12 @@
 			J721E_IOPAD(0xe4, PIN_INPUT, 8) /* (V1) TIMER_IO0.MMC1_SDCD */
 		>;
 	};
+
+	main_usbss0_pins_default: main_usbss0_pins_default {
+		pinctrl-single,pins = <
+			J721E_IOPAD(0x120, PIN_OUTPUT, 0) /* (T4) USB0_DRVVBUS */
+		>;
+	};
 };
 
 &wkup_uart0 {
@@ -145,3 +151,19 @@
 	idle-states = <SERDES0_LANE0_PCIE1_LANE0>, <SERDES0_LANE1_PCIE1_LANE1>,
 		      <SERDES0_LANE2_QSGMII_LANE1>, <SERDES0_LANE3_IP4_UNUSED>;
 };
+
+&usb_serdes_mux {
+	idle-states = <1>; /* USB0 to SERDES lane 3 */
+};
+
+&usbss0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&main_usbss0_pins_default>;
+	ti,vbus-divider;
+	ti,usb2-only;
+};
+
+&usb0 {
+	dr_mode = "otg";
+	maximum-speed = "high-speed";
+};
-- 
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki