[PATCH v2] drm/bridge/synopsys: dsi: allow LP commands in video mode

[Neil Armstrong]

On 08/07/2020 16:08, Yannick Fertre wrote:
> From: Antonio Borneo <antonio.borneo at st.com>
> 
> Current code only sends LP commands in command mode.
> 
> Allows sending LP commands also in video mode by setting the
> proper flag in DSI_VID_MODE_CFG.
> 
> Signed-off-by: Antonio Borneo <antonio.borneo at st.com>
> ---
>  drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c | 8 ++++++++
>  1 file changed, 8 insertions(+)
> 
> diff --git a/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c b/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> index 1a24ea648ef8..e9a0f42ff99f 100644
> --- a/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> +++ b/drivers/gpu/drm/bridge/synopsys/dw-mipi-dsi.c
> @@ -89,6 +89,7 @@
>  #define VID_MODE_TYPE_NON_BURST_SYNC_EVENTS	0x1
>  #define VID_MODE_TYPE_BURST			0x2
>  #define VID_MODE_TYPE_MASK			0x3
> +#define ENABLE_LOW_POWER_CMD		BIT(15)
>  #define VID_MODE_VPG_ENABLE		BIT(16)
>  #define VID_MODE_VPG_HORIZONTAL		BIT(24)
>  
> @@ -376,6 +377,13 @@ static void dw_mipi_message_config(struct dw_mipi_dsi *dsi,
>  
>  	dsi_write(dsi, DSI_LPCLK_CTRL, lpm ? 0 : PHY_TXREQUESTCLKHS);
>  	dsi_write(dsi, DSI_CMD_MODE_CFG, val);
> +
> +	val = dsi_read(dsi, DSI_VID_MODE_CFG);
> +	if (lpm)
> +		val |= ENABLE_LOW_POWER_CMD;
> +	else
> +		val &= ~ENABLE_LOW_POWER_CMD;
> +	dsi_write(dsi, DSI_VID_MODE_CFG, val);
>  }
>  
>  static int dw_mipi_dsi_gen_pkt_hdr_write(struct dw_mipi_dsi *dsi, u32 hdr_val)
> 

Tested on Amlogic AXG (v1.21a)

Acked-by: Neil Armstrong <narmstrong at baylibre.com>

Applying to drm-misc-next

Thanks !
Neil