[PATCH 7/7] arm64: dts: marvell: Add a device tree for the iEi Puzzle-M801 board
Andrew Lunn
andrew at lunn.ch
Sat Sep 5 11:21:22 EDT 2020
On Sat, Sep 05, 2020 at 03:03:36PM +0200, Luka Kovacic wrote:
> +&cp0_mdio {
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + status = "okay";
> +
> + ge_phy2: ethernet-phy at 2 {
> + reg = <0>;
Hi Luka
The value after the @ should be the same as the reg value.
So this should be ge_phy2: ethernet-phy at 0
> + };
> +
> + ge_phy3: ethernet-phy at 3 {
> + reg = <1>;
And this is:
ge_phy2: ethernet-phy at 1
This is a general DT rule, so please check the whole file.
> +&cp0_eth0 {
> + status = "okay";
> + phy-mode = "10gbase-r";
> + phys = <&cp0_comphy4 0>;
> + local-mac-address = [00 50 43 de ff 00];
Does the bootloader overwrite these with per device MAC addresses?
Looking up this OUI i find:
00:50:43 Marvell Semiconductor, Inc.
I'm not sure you should be using that!
Andrew
More information about the linux-arm-kernel
mailing list