[PATCH v2 18/23] iommu/mediatek: Support up to 34bit iova in tlb flush

[Yong Wu]

If the iova is 34bit, the iova[32][33] is the bit0/1 in the tlb flush
register. Add a new macro for this.

there is a minor change unrelated with this patch. it also use the new
macro.

Signed-off-by: Yong Wu <yong.wu at mediatek.com>
---
 drivers/iommu/mtk_iommu.c | 11 +++++++----
 1 file changed, 7 insertions(+), 4 deletions(-)

diff --git a/drivers/iommu/mtk_iommu.c b/drivers/iommu/mtk_iommu.c
index 54cad923ae16..9fe9a706742c 100644
--- a/drivers/iommu/mtk_iommu.c
+++ b/drivers/iommu/mtk_iommu.c
@@ -125,6 +125,9 @@ static const struct iommu_ops mtk_iommu_ops;
 
 static int mtk_iommu_hw_init(const struct mtk_iommu_data *data);
 
+#define MTK_IOMMU_ADDR(addr) ({unsigned long _addr = addr; \
+			      (lower_32_bits(_addr) | upper_32_bits(_addr)); })
+
 /*
  * In M4U 4GB mode, the physical address is remapped as below:
  *
@@ -213,8 +216,9 @@ static void mtk_iommu_tlb_flush_range_sync(unsigned long iova, size_t size,
 		writel_relaxed(F_INVLD_EN1 | F_INVLD_EN0,
 			       data->base + data->plat_data->inv_sel_reg);
 
-		writel_relaxed(iova, data->base + REG_MMU_INVLD_START_A);
-		writel_relaxed(iova + size - 1,
+		writel_relaxed(MTK_IOMMU_ADDR(iova),
+			       data->base + REG_MMU_INVLD_START_A);
+		writel_relaxed(MTK_IOMMU_ADDR(iova + size - 1),
 			       data->base + REG_MMU_INVLD_END_A);
 		writel_relaxed(F_MMU_INV_RANGE,
 			       data->base + REG_MMU_INVALIDATE);
@@ -634,8 +638,7 @@ static int mtk_iommu_hw_init(const struct mtk_iommu_data *data)
 	if (data->plat_data->m4u_plat == M4U_MT8173)
 		regval = (data->protect_base >> 1) | (data->enable_4GB << 31);
 	else
-		regval = lower_32_bits(data->protect_base) |
-			 upper_32_bits(data->protect_base);
+		regval = MTK_IOMMU_ADDR(data->protect_base);
 	writel_relaxed(regval, data->base + REG_MMU_IVRP_PADDR);
 
 	if (data->enable_4GB &&
-- 
2.18.0