[PATCH v3 13/14] dt-bindings: mtd: nand-controller: Fix matching with size-cells==1

[Rob Herring]

On Fri, Sep 4, 2020 at 9:25 AM Krzysztof Kozlowski <krzk at kernel.org> wrote:
>
> Most of Freescale/NXP GPMI device trees use size-cells==1 (even when
> actually not needed except few boards).  This fixes dtbs_check warnings
> like:
>
>     arch/arm64/boot/dts/freescale/imx8mm-beacon-kit.dt.yaml: nand-controller at 33002000: #size-cells:0:0: 0 was expected
>
> Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> ---
>  Documentation/devicetree/bindings/mtd/nand-controller.yaml | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/mtd/nand-controller.yaml b/Documentation/devicetree/bindings/mtd/nand-controller.yaml
> index 40fc5b0b2b8c..0879e1108837 100644
> --- a/Documentation/devicetree/bindings/mtd/nand-controller.yaml
> +++ b/Documentation/devicetree/bindings/mtd/nand-controller.yaml
> @@ -34,7 +34,10 @@ properties:
>      const: 1
>
>    "#size-cells":
> -    const: 0
> +    description:
> +      Depends on your controller. Put zero unless you need a mapping between CS
> +      lines and dedicated memory regions.
> +    enum: [0, 1]

Humm, seems that was to describe partitions, but the expectation of
the nand binding is describing nand chips. It seems the nand chips are
never described and on 1 board even has partitions. I think you should
fix the dts to move 'partition at N' nodes under 'partitions' which is
preferred and needed if you ever describe nand chips. And then fix
'#size-cells' to be 0.

Rob