[PATCH v2 0/3] pinctrl: Adding support for Microchip/Microsemi serial GPIO controller

[Lars Povlsen]

The series add support for the serial GPIO controller used by
Microchip Sparx5, as well as (MSCC) ocelot/jaguar2 SoCs.

This is the second revision of the patch series.

v2 changes:
- Adds both in and output modes.
- Use direct adressing of the individual banks (#gpio-cells = <4>),
  also osoleting need for addressing macros in bindings include file.
- Property 'microchip,sgpio-ports' (uint32, bitmask) replaced by
  proper range set (array of [start,end]) 'microchip,sgpio-port-ranges'.
- Fixes whitespace issues in Kconfig file

Lars Povlsen (3):
  dt-bindings: pinctrl: Add bindings for pinctrl-mchp-sgpio driver
  pinctrl: pinctrl-mchp-sgpio: Add pinctrl driver for Microsemi Serial
    GPIO
  arm64: dts: sparx5: Add SGPIO devices

 .../pinctrl/microchip,sparx5-sgpio.yaml       |  88 +++
 MAINTAINERS                                   |   1 +
 arch/arm64/boot/dts/microchip/sparx5.dtsi     |  52 ++
 .../boot/dts/microchip/sparx5_pcb125.dts      |   5 +
 .../dts/microchip/sparx5_pcb134_board.dtsi    |   5 +
 .../dts/microchip/sparx5_pcb135_board.dtsi    |   5 +
 drivers/pinctrl/Kconfig                       |  17 +
 drivers/pinctrl/Makefile                      |   1 +
 drivers/pinctrl/pinctrl-mchp-sgpio.c          | 642 ++++++++++++++++++
 include/dt-bindings/gpio/mchp-sgpio.h         |  19 +
 10 files changed, 835 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/pinctrl/microchip,sparx5-sgpio.yaml
 create mode 100644 drivers/pinctrl/pinctrl-mchp-sgpio.c
 create mode 100644 include/dt-bindings/gpio/mchp-sgpio.h

--
2.27.0