[PATCH 5.9 621/757] ARM: dts: stm32: Swap PHY reset GPIO and TSC2004 IRQ on DHCOM SOM

[Greg Kroah-Hartman]

From: Marek Vasut <marex at denx.de>

[ Upstream commit 9ad98319e95263469d8ca2cb543c37c5a2f40980 ]

On the production revision of the SoM, 587-200, the PHY reset GPIO and
touchscreen IRQs are swapped to prevent collision between EXTi IRQs,
reflect that in DT.

Fixes: 34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board")
Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: Patrick Delaunay <patrick.delaunay at st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
Signed-off-by: Alexandre Torgue <alexandre.torgue at st.com>
Signed-off-by: Sasha Levin <sashal at kernel.org>
---
 arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
index d30a3c60da9b0..a87ebc4843963 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi
@@ -117,7 +117,7 @@ &ethernet0 {
 	max-speed = <100>;
 	phy-handle = <&phy0>;
 	st,eth-ref-clk-sel;
-	phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>;
+	phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>;
 
 	mdio0 {
 		#address-cells = <1>;
@@ -285,7 +285,7 @@ touchscreen at 49 {
 		compatible = "ti,tsc2004";
 		reg = <0x49>;
 		vio-supply = <&v3v3>;
-		interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>;
+		interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>;
 	};
 
 	eeprom at 50 {
-- 
2.25.1