[PATCH] arm64: dts: ti: k3-j7200-main: Add McASP nodes

[Tony Lindgren]

* Nishanth Menon <nm at ti.com> [201026 14:58]:
> On 13:38-20201007, Peter Ujfalusi wrote:
> [...]
> > >>>> +		status = "disabled";
> > >>>
> > >>> I see that there is inconsistent usage of "disabled" in our SoC.dts
> > >>>
> > >>> Our generic rule has been set them to disabled in board.dtsi
> > >>> McASP and DSS for existing SoC dts do not follow this.. which is a tad
> > >>> confusing.. (considering that not even all uarts come out on every board
> > >>> and every uart needs pinmux to function..)
> > >>
> > >> "keep them disabled because several required properties are not present
> > >> as they are board specific."
> > >>
> > >> In board file the enabled mcasp must be updated with options that is
> > >> required for operation. Without those option the McASP can not be
> > >> initialized.
> > >>
> > >> I think we have been revisiting the very same discussion every time we
> > >> have a new SoC with McASP...
> > >>
> > > 
> > > Yep.. This doe'snt really follow the rest of the SoC definition. [1]
> > > came to mind. The McASP discussion is a variation in the debate of the
> > > same.
> > 
> > Right, saying status = "okay" to a node which is missing required
> > properties (which can only be added by boards when the McASP is
> > connected up) does not sound a good solution.
> > How should the SW handle that? Fail the device probe and return with
> > -EINVAL or eat up the error and just probe with broken configuration.
> > Since the peripheral is not used, the broken configuration will not
> > cause much runtime errors as there will be no runtime use of the peripheral.
> > 
> > status of fail or fail-sss is not a good one either, their definition is:
> > "Indicates that the device is not operational. A serious error was
> > detected in the device, and it is unlikely to become operational without
> > repair."
> > 
> > The peripheral is fine, we are just trying to enable it without
> > providing the needed properties.
> > 
> > > I'd argue Serdes, or for that matter any IP that has a link to
> > > outside-the-SoC world has the same discussion point.
> > 
> > status = "disabled" is still the closest thing for everything which have
> > external dependencies. There is not much point to enable an i2c bus
> > without making sure that the signals are actually routed to the pins
> > where they supposed to go.

There is one reason to keep using the default status = "okay", for
i2c Linux can properly idle the device on boot without dependencies
to a certain boot loader version.

> > Or from other pow: a board design is not based on what is _not_
> > connected to outside world, but you actually _connect_ or _enable_
> > certain peripherals to external components, connectors.
> 
> OK, I will buy the argument that the current status thingy is a bit
> overloaded and does'nt imply the correct state we need it to imply with
> "fail-sss" either - I remember an argument for "fail-incomplete", but
> that never happened anyways.
> 
> Lets add this argument to the commit message and repost after testing
> on 5.10-rc1 please?

We should use status = "disabled" when the hardware is not accessible
to the SoC. That goes for things like secure world devices, and hardware
that relies on a missing external clock for example. For other things
we should just stick to the default which "okay" :)

Regards,

Tony