[PATCH 10/14] ARM: dts: sun8i: v3s: Add MIPI D-PHY and MIPI CSI-2 interface nodes

[Maxime Ripard]

On Fri, Oct 23, 2020 at 07:45:42PM +0200, Paul Kocialkowski wrote:
> MIPI CSI-2 is supported on the V3s with an A31 controller, which seems
> to be used on all Allwinner chips supporting it, except for the A83T.
> The controller is connected to CSI0 through fwnode endpoints.
> The mipi_csi2_in port node is provided to connect MIPI CSI-2 sensors.
> 
> The D-PHY part is the same that already drives DSI, but used in Rx mode.
> 
> Signed-off-by: Paul Kocialkowski <paul.kocialkowski at bootlin.com>

Especially since you haven't tested CSI0 without MIPI-CSI, you can
squash that patch into the previous one.

Maxime
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20201026/6b12c38c/attachment.sig>