[PATCH V3 1/4] gpio: mxc: Support module build

[Aisheng Dong]

Hi Shawn,

> From: Anson Huang <anson.huang at nxp.com>
> Sent: Monday, October 12, 2020 7:36 PM
> 
> Hi, Shawn
> 
> > Subject: Re: [PATCH V3 1/4] gpio: mxc: Support module build
> >
> > On Thu, Sep 17, 2020 at 7:40 AM Anson Huang <Anson.Huang at nxp.com>
> > wrote:
> >
> > > Change config to tristate, add module device table, module author,
> > > description and license to support module build for i.MX GPIO driver.
> > >
> > > As this is a SoC GPIO module, it provides common functions for most
> > > of the peripheral devices, such as GPIO pins control, secondary
> > > interrupt controller for GPIO pins IRQ etc., without GPIO driver,
> > > most of the peripheral devices will NOT work properly, so GPIO
> > > module is similar with clock, pinctrl driver that should be loaded
> > > ONCE and never unloaded.
> > >
> > > Since MXC GPIO driver needs to have init function to register
> > > syscore ops once, here still use subsys_initcall(), NOT
> module_platform_driver().
> > >
> > > Signed-off-by: Anson Huang <Anson.Huang at nxp.com>
> >
> > This patch (1) applied to the GPIO tree.
> > Please apply the rest through the ARM SoC tree!
> >
> 
> Could you please help pick the rest patch of this series? Otherwise, the i.MX
> GPIO driver will NOT be enabled by default and it will block kernel boot.

This blocked a huge number of i.MX boards booting with latest linux-next kernel.
Would you help pick it ASAP?

Regards
Aisheng

> 
> Thanks,
> Anson