[PATCH] ARM: dts: stm32: Consistently enable internal pull-ups for SD bus

[Marek Vasut]

The default state of SD bus and clock line is logical HI. SD card IO is
open-drain and pulls the bus lines LO. Always enable the SD bus pull ups
to guarantee this behavior. Note that on systems with bus voltage level
shifter on the SD bus, the pull ups might also be built into the level
shifter, however that should have no negative impact.

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: Patrick Delaunay <patrick.delaunay at st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
---
 arch/arm/boot/dts/stm32mp15-pinctrl.dtsi | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
index b2d19583450c..73d9a5b7f5ba 100644
--- a/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
+++ b/arch/arm/boot/dts/stm32mp15-pinctrl.dtsi
@@ -1291,13 +1291,13 @@ pins1 {
 				 <STM32_PINMUX('D', 2, AF12)>; /* SDMMC1_CMD */
 			slew-rate = <1>;
 			drive-push-pull;
-			bias-disable;
+			bias-pull-up;
 		};
 		pins2 {
 			pinmux = <STM32_PINMUX('C', 12, AF12)>; /* SDMMC1_CK */
 			slew-rate = <2>;
 			drive-push-pull;
-			bias-disable;
+			bias-pull-up;
 		};
 	};
 
@@ -1447,13 +1447,13 @@ pins1 {
 				 <STM32_PINMUX('G', 6, AF10)>; /* SDMMC2_CMD */
 			slew-rate = <1>;
 			drive-push-pull;
-			bias-disable;
+			bias-pull-up;
 		};
 		pins2 {
 			pinmux = <STM32_PINMUX('E', 3, AF9)>; /* SDMMC2_CK */
 			slew-rate = <2>;
 			drive-push-pull;
-			bias-disable;
+			bias-pull-up;
 		};
 	};
 
@@ -1510,7 +1510,7 @@ pins {
 				 <STM32_PINMUX('C', 7, AF10)>; /* SDMMC2_D7 */
 			slew-rate = <1>;
 			drive-push-pull;
-			bias-disable;
+			bias-pull-up;
 		};
 	};
 
-- 
2.28.0