[PATCH] ARM: dts: stm32: Fix TA3-GPIO-C key on STM32MP1 DHCOM PDK2

[Marek Vasut]

On the prototype DHCOM, the TA3-GPIO-C button was connected to pin PI11 of
the STM32MP15xx, however on the production SoM this was changed to pin PG0
to free up the IRQ line 11 for LAN8710i PHY IRQ. Update the connection in
the DT. Since the IRQ line 0 is used for PMIC as well and cannot be shared
with the button, make the button polled.

Fixes: 87cabf9405cb ("ARM: dts: stm32: Add GPIO keys for STM32MP1 DHCOM PDK2")
Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Alexandre Torgue <alexandre.torgue at st.com>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Patrice Chotard <patrice.chotard at st.com>
Cc: Patrick Delaunay <patrick.delaunay at st.com>
Cc: linux-stm32 at st-md-mailman.stormreply.com
To: linux-arm-kernel at lists.infradead.org
---
 arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi | 17 ++++++++++-------
 1 file changed, 10 insertions(+), 7 deletions(-)

diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
index 5dff24e39af8..9a0a59678097 100644
--- a/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
+++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-pdk2.dtsi
@@ -46,6 +46,16 @@
 			linux,code = <KEY_A>;
 			gpios = <&gpiof 3 GPIO_ACTIVE_LOW>;
 		};
+
+		/*
+		 * The EXTi IRQ line 0 is shared with PMIC,
+		 * so mark this as polled GPIO key.
+		 */
+		button-2 {
+			label = "TA3-GPIO-C";
+			linux,code = <KEY_C>;
+			gpios = <&gpiog 0 GPIO_ACTIVE_LOW>;
+		};
 	};
 
 	gpio-keys {
@@ -59,13 +69,6 @@
 			wakeup-source;
 		};
 
-		button-2 {
-			label = "TA3-GPIO-C";
-			linux,code = <KEY_C>;
-			gpios = <&gpioi 11 GPIO_ACTIVE_LOW>;
-			wakeup-source;
-		};
-
 		button-3 {
 			label = "TA4-GPIO-D";
 			linux,code = <KEY_D>;
-- 
2.28.0