[PATCH v4 1/3] dt-bindings: pinctrl: Add bindings for pinctrl-mchp-sgpio driver

Lars Povlsen lars.povlsen at microchip.com
Thu Oct 8 07:43:48 EDT 2020


Linus Walleij writes:

> Hi Lars,
>
> a new version of the patch set arrives while I'm reviewing, haha :D

Well, luckily not too much changed per Rob's input.

>
> On Wed, Oct 7, 2020 at 1:12 PM Lars Povlsen <lars.povlsen at microchip.com> wrote:
>
>> This adds DT bindings for the Microsemi/Microchip SGPIO controller,
>> bindings microchip,sparx5-sgpio, mscc,ocelot-sgpio and
>> mscc,luton-sgpio.
>>
>> Signed-off-by: Lars Povlsen <lars.povlsen at microchip.com>
>
> (...)
>> +      reg:
>> +        description: |
>> +          The GPIO bank number. "0" is designates the input pin bank,
>> +          "1" the output bank.
>> +        maxItems: 1
>
> Excellent.
>
>> +      '#gpio-cells':
>> +        const: 3
>
> So I thought you needed three cells exactly because the
> middle cell would get you the bank. That you now have in
> reg. So what about using the standard twocell?

I think I answered that in the 'v3 2/3' reply.

Basically the pins are addressed with two indices, and there are good
reasons to expose these to the GPIO cells, f.ex. hardware documentation
cross reference.

---Lars

>
> Yours,
> Linus Walleij

-- 
Lars Povlsen,
Microchip



More information about the linux-arm-kernel mailing list