[PATCH v3 7/9] spi: spi-s3c64xx: Ensure cur_speed holds actual clock value

[Łukasz Stelmach]

Make sure the cur_speed value used in s3c64xx_enable_datapath()
to configure DMA channel and in s3c64xx_wait_for_*() to calculate the
transfer timeout is set to the actual value of (half) the clock speed.

Don't change non-CMU case, because no frequency calculation errors have
been reported.

Reviewed-by: Krzysztof Kozlowski <krzk at kernel.org>
Suggested-by: Tomasz Figa <tomasz.figa at gmail.com>
Signed-off-by: Łukasz Stelmach <l.stelmach at samsung.com>
---
 drivers/spi/spi-s3c64xx.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index f85f40fd608c..0bd3e230350c 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -626,6 +626,7 @@ static int s3c64xx_spi_config(struct s3c64xx_spi_driver_data *sdd)
 		ret = clk_set_rate(sdd->src_clk, sdd->cur_speed * 2);
 		if (ret)
 			return ret;
+		sdd->cur_speed = clk_get_rate(sdd->src_clk) / 2;
 	} else {
 		/* Configure Clock */
 		val = readl(regs + S3C64XX_SPI_CLK_CFG);
-- 
2.26.2