[PATCH 0/8] Add support for UHS modes in TI's J721e and J7200 boards

[Nishanth Menon]

On 00:35-20201002, Faiz Abbas wrote:
> The following patches add support for UHS modes for TI's j721e and j7200
> boards.
> 
> Patches 1-3 add support for gpios to j7200-evm
> 
> Patches 4-6 add support for voltage regulators for required by the
> SD card in both devices as well as enable UHS modes at 1.8V
> 
> Patches 5-6 add some required configs to the arm64 defconfig.
> 
> This series depends on driver patches adding tuning support here:
> https://lore.kernel.org/linux-arm-kernel/20200923105206.7988-1-faiz_abbas@ti.com/
> 
> Faiz Abbas (8):
>   arm64: dts: ti: k3-j7200-main: Add gpio nodes in main domain
>   arm64: dts: ti: k3-j7200: Add gpio nodes in wakeup domain
>   arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
>     modules
>   arm64: dts: ti: k3-j721e-main: Add output tap delay values
>   arm64: dts: ti: k3-j721e-common-proc-board: Add support SD card UHS
>     modes
>   arm64: dts: ti: k3-j7200-common-proc-board: Add support SD card UHS
>     modes

Split these up please!
>   arm64: defconfig: Enable OMAP I2C driver
>   arm64: defconfig: Enable DAVINCI_GPIO driver
> 

defconfig patches can be posted independent of dts patches, they go to
different branches.

Also, These are a little too late for 5.10 at this point.
>  .../dts/ti/k3-j7200-common-proc-board.dts     | 48 +++++++++++++
>  arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 69 ++++++++++++++++++-
>  .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 32 +++++++++
>  .../dts/ti/k3-j721e-common-proc-board.dts     | 35 +++++++++-
>  arch/arm64/boot/dts/ti/k3-j721e-main.dtsi     | 22 ++++--
>  arch/arm64/configs/defconfig                  |  2 +
>  6 files changed, 201 insertions(+), 7 deletions(-)
> 
> -- 
> 2.17.1
> 

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D