[PATCH v5 80/80] ARM: dts: bcm2711: Enable the display pipeline

[Nicolas Saenz Julienne]

Hi Tim, thanks for the info!

On Thu, 2020-10-01 at 11:15 +0100, Tim Gover wrote:
> hdmi_enable_4k60=1 causes the firmware to select 3.3 GHz for the PLLC
> VCO to support a core-frequency of 550 MHz which is the minimum
> frequency required by the HVS at 4Kp60. The side effect is that if the
> display clock requirements are lower than 4Kp60 then you will see
> different core frequencies selected by DVFS.
> 
> If enable_uart=1 and the mini-uart is selected (default unless

What is the actual test made to check if mini-uart is selected? I can't get
firmware to trigger this behaviour with 64-bit upstream kernel/dts. Note that I
see the core clk setup at 200MHz just before having VC4 set it to 500MHz.

The only thing I've got on my config.txt is:

enable_uart=1
arm_64bit=1

Maybe we're missing some kind of DT alias upstream?

Regards,
Nicolas

> bluetooth is disabled) then the firmware will pin the core-frequency
> to either core_freq max (500 or 550). Although, I think there is a way
> of pinning it to a lower fixed frequency.
> 
> The table in overclocking.md defines options for setting the maximum
> core frequency but unless core_freq_min is specified DVFS will
> automatically pick the lowest idle frequency required by the display
> resolution.

-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 488 bytes
Desc: This is a digitally signed message part
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20201001/1d022a0a/attachment.sig>