[PATCH v3 1/2] arm64: dts: Add the Kontron i.MX8M Mini SoMs and baseboards

[Krzysztof Kozlowski]

On Thu, Oct 01, 2020 at 02:06:58PM +0200, Schrempf Frieder wrote:
> From: Frieder Schrempf <frieder.schrempf at kontron.de>
> 
> Kontron Electronics GmbH offers small and powerful SoMs based on the
> i.MX8M Mini SoC including PMIC, LPDDR4-RAM, eMMC and SPI NOR.
> 
> The matching baseboards have the same form factor and similar interfaces
> as the other boards from the Kontron "Board-Line" family, including
> SD card, 1G Ethernet, 100M Ethernet, USB Host/OTG, digital IOs, RS232,
> RS485, CAN, LVDS or HDMI, RTC and much more.
> 
> Signed-off-by: Frieder Schrempf <frieder.schrempf at kontron.de>
> ---
> Changes for v3:
> * Remove needless status properties
> * Remove needless regulator properties for reg_vdd_5v
> * Use proper PHY reset properties in PHY node
> * Use phy-connection-type instead of phy-mode
> * Adjust PMIC node name and label
> * Add over-current-active-low to usbotg1 node
> * Remove redundant bus-width property from usdhc2 node
> * Remove needless regulator-compatible from reg_vdd_snvs
> * Set minimum voltage to 85mV for reg_vdd_snvs
> 
> Changes for v2:
> * Make the licensing less strict (GPL-2.0+ OR MIT)
> * Merge the SoM and baseboard DTs for N8010 and N8011 into one as
>   they only differ in DDR and eMMC size.
> * Change compatibles and model strings to "n810x" and "N8010X".
> * Only use a common memory node that will be updated by the
>   bootloader reflecting the detected DDR size.
> * Improve naming for 16MHz CAN fixed oscillator and set
>   "clock-output-names".
> * Consistently use "reg_" prefix for regulators.
> * Remove "userspi" node.
> * Slightly improve commit message.
> ---
>  .../dts/freescale/imx8mm-kontron-n801x-s.dts  | 323 ++++++++++++++++++
>  .../freescale/imx8mm-kontron-n801x-som.dtsi   | 293 ++++++++++++++++
>  2 files changed, 616 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-s.dts
>  create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-kontron-n801x-som.dtsi

Ah, and one more issue - missing Makefile entry? This won't build.

Best regards,
Krzysztof