[RFC 0/4] net: l2switch: Provide support for L2 switch on i.MX28 SoC

Lukasz Majewski lukma at denx.de
Fri Nov 27 04:25:28 EST 2020


Hi Andrew,

> > > I would push back and say that the switch offers bridge
> > > acceleration for the FEC.   
> > 
> > Am I correct, that the "bridge acceleration" means in-hardware
> > support for L2 packet bridging?   
> 
> You should think of the hardware as an accelerator, not a switch. The
> hardware is there to accelerate what linux can already do. You setup a
> software bridge in linux, and then offload L2 switching to the
> accelerator. You setup vlans in linux, and then offload the filtering
> of them to the accelerator. If there is something linux can do, but
> the hardware cannot accelerate, you leave linux to do it in software.

Ok.

> 
> > Do you propose to catch some kind of notification when user calls:
> > 
> > ip link add name br0 type bridge; ip link set br0 up;
> > ip link set lan1 up; ip link set lan2 up;
> > ip link set lan1 master br0; ip link set lan2 master br0;
> > bridge link
> > 
> > And then configure the FEC driver to use this L2 switch driver?  
> 
> That is what switchdev does. There are various hooks in the network
> stack which call into switchdev to ask it to offload operations to the
> accelerator.

Ok.

> 
> > The differences from "normal" DSA switches:
> > 
> > 1. It uses mapped memory (for its register space) for
> > configuration/statistics gathering (instead of e.g. SPI, I2C)  
> 
> That does not matter. And there are memory mapped DSA switches. The
> DSA framework puts no restrictions on how the control plane works.
> 
> > (Of course the "Section 32.5.8.2" is not available)  
> 
> It is in the Vybrid datasheet :-)

Hmm...

I cannot find such chapter in the official documentation from NXP:
"VFxxx Controller Reference Manual, Rev. 0, 10/2016"

Maybe you have more verbose version? Could you share how the document
is named?

> 
>    Andrew


Best regards,

Lukasz Majewski

--

DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-59 Fax: (+49)-8142-66989-80 Email: lukma at denx.de
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 488 bytes
Desc: OpenPGP digital signature
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20201127/3e972a11/attachment.sig>


More information about the linux-arm-kernel mailing list