[PATCH v7 1/3] dt-bindings: arm: remove optional properties for SCMI Regulators

[Cristian Marussi]

Remove optional properties bindings descriptions for SCMI Regulators.

Signed-off-by: Cristian Marussi <cristian.marussi at arm.com>
---
 Documentation/devicetree/bindings/arm/arm,scmi.txt | 11 +----------
 1 file changed, 1 insertion(+), 10 deletions(-)

diff --git a/Documentation/devicetree/bindings/arm/arm,scmi.txt b/Documentation/devicetree/bindings/arm/arm,scmi.txt
index 6e011ca97079..b5ce5b39bb9c 100644
--- a/Documentation/devicetree/bindings/arm/arm,scmi.txt
+++ b/Documentation/devicetree/bindings/arm/arm,scmi.txt
@@ -71,20 +71,11 @@ It does not support any current operation.
 SCMI Regulators are grouped under a 'regulators' node which in turn is a child
 of the SCMI Voltage protocol node inside the desired SCMI instance node.
 
-This binding uses the common regulator binding[6] but, due to SCMI abstractions,
-supports only a subset of its properties as specified below amongst Optional
-properties.
+This binding uses the common regulator binding[6].
 
 Required properties:
  - reg : shall identify an existent SCMI Voltage Domain.
 
-Optional properties:
- - regulator-name
- - regulator-min-microvolt / regulator-max-microvolt
- - regulator-always-on / regulator-boot-on
- - regulator-max-step-microvolt
- - regulator-coupled-with / regulator-coupled-max-spread
-
 Sensor bindings for the sensors based on SCMI Message Protocol
 --------------------------------------------------------------
 SCMI provides an API to access the various sensors on the SoC.
-- 
2.17.1